Sounds good. Do I need to replace both, or is there a way to see which one doesn't work?
Also I did some more testing...the ignitor works fine. I took the front panel off to observe the issue. The dryer will start after it has been idle for a while, ignitor goes on and a couple second later the flame ignites. During the cycle, the ignitor goes out and the flame will continue. After a period of time the flame goes out. (I am assuming up to this point this is normal). Then after a minute or so, the ignitor goes back on, glows, but then turns itself off. This will repeat and the flame will not go back on. Once in a while the flame will go back on, but most of the time the ignitor glows and then stops. Even after a while where the dryer is not hot at all.
Is this this the coils, or could it be the flame sensor, or a temperature sensor?
Thanks for the quick response.