Author Topic: Kenmore series 70 washer spin  (Read 3171 times)

Offline cgarza1

  • VIP Member
  • Member Since: May 2010
  • Posts: 1
Kenmore series 70 washer spin
« on: May 27, 2010, 01:02:32 PM »
My washer won't spin at all. it will do everything else but spin. I do have it taking apart and the coupling is fine. I did noticed with the pump running out of the washer and connected to the gear case the pole sticking out of it spins but it you put pressure on it it will stop. it turns slow with no pressure on it. would I need the whole gear case to fix my problem, maybe gears are worn?

Model 11026732500

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Kenmore series 70 washer spin
« Reply #1 on: May 27, 2010, 02:08:51 PM »
Get the clutch off and remove the tranny cover. Look for a worn main drive gear. Then remove the main drive gear and look at the spin pawl. The spin pawl has to catch a boss under that main drive gear in order to make the tranny spin. With wear the spin pawl gets smashed down and won't CATCH one of them bosses. Their are 3 bosses. Here is how it works during the wash cycle the spin pawl is moved to the inside and held into place by the spin pawl keeper. When the wash cycle ends the motor reverses and takes off pumping out the water. after 5 minutes of water pumping the timer stops for one minute. The stopping force releases and propels the spin pawl away from the middle where is is allowed to catch one of 3 bosses underneath the main drive gear. You can make it do it anytime by stopping the timer while in spin and starting it again after a slight pause. This transmission in the direct drive world is know as a Neutral drain type tranny. Original models did not have a neutral drain tranny, they spun and drained at the same time. It is a very easy fix. Use this nice guide provided by fearless leader: WHIRLPOOL D.D. TRAINING MANUAL
« Last Edit: May 27, 2010, 02:22:18 PM by JWWebster »
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline whirlpooltech

  • Technician
  • Member Since: Nov 2007
  • Posts: 1367
  • Country: us
  • 20 years of experience
Re: Kenmore series 70 washer spin
« Reply #2 on: May 27, 2010, 03:00:19 PM »
Does the motor run or try to run during the spin cycle?

If the motor does not run or does not try to run during the spin you may have a bad lid switch.

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: Kenmore series 70 washer spin
« Reply #3 on: May 27, 2010, 03:09:28 PM »
Remove the pump and see what is stuck inside the pump.
Take a Kid fishing.

Offline Washaman

  • Technician
  • Member Since: Jul 2009
  • Posts: 495
  • Country: us
Re: Kenmore series 70 washer spin
« Reply #4 on: May 29, 2010, 09:45:57 PM »
I see this all the time and JW is right on the money. Also the basket drive could be causing excessive drag if worn out. Was the bottom of the tranny covered in oil when removed?

 

kenmore 90 series washer wont spin

Started by barnett74

Replies: 3
Views: 4126
Last post December 27, 2008, 04:33:31 AM
by Repair-man
Kenmore 90 Series Washer with Spin Cycle issues

Started by B_con

Replies: 2
Views: 2982
Last post February 28, 2009, 08:27:56 PM
by JWWebster
Kenmore 70 Series Washer No Spin

Started by Grinch383

Replies: 13
Views: 23430
Last post August 05, 2009, 05:29:02 PM
by JWWebster
Kenmore 70 Series Washer No Spin

Started by Hilory

Replies: 5
Views: 2593
Last post August 27, 2009, 08:32:35 PM
by AJ
Kenmore 70 Series Washer - no cold water, weak spin cycle?

Started by Q451990

Replies: 10
Views: 4006
Last post January 28, 2010, 08:31:18 PM
by viking351
Kenmore 80 series washer will not spin

Started by Hotpot

Replies: 6
Views: 7291
Last post June 09, 2010, 07:13:15 PM
by Repair-man