Author Topic: Touch Screen error on G2Microven  (Read 2508 times)

Offline hockeyham

  • VIP Member
  • Member Since: Jul 2010
  • Posts: 1
Touch Screen error on G2Microven
« on: July 26, 2010, 11:29:30 PM »
Hi:

New to board, did thorough search but did not find any results for this model number Microwave/Range oven we just acquired this past weekend.

The touchscreen on the Whirlpool G2Microven does not work. When I plug in the the Microven, the touchpad beeps "TOUCH" in morse code (I'm a ham op, and recognized the CW on bootup) and a message board appears on the display indicating "TOUCH ERROR" with the following info:

Y High Pass 255 255
Y HiLo Pass 252 3
Y Low Pass 1 0

X High Fail 255 04
X HiLo Pass 255 0
X Low Fail 236 0

Image of above error (hopefully) attached.

Oven was manufactured in April, 2006. We acquired it along with a Whirlpool fridge, dishwasher, and stove. So far this is only hiccup.

Ive checked all known fuses and none look blown.

One other note is that before I removed the panel where the touchpad was and inspected the boards, I was getting "FAIL" not only on X High and X Low but also Y High and Y Low with both X HiLo and Y HiLo passing.

Any advise is appreciated.

Model GH6177XPS3

 

7" Touch Screen Panel/Module for Late Model Jenn Built-ins (Scrap For Grab)

Started by rmbraught

Replies: 2
Views: 1938
Last post June 18, 2010, 04:05:10 PM
by rmbraught
Whirlpool Microwave F2Q1 Error Code

Started by TechnicianBrian

Replies: 0
Views: 2489
Last post April 15, 2008, 09:57:53 PM
by TechnicianBrian
Whirlpool Polara Range Error Code

Started by TechnicianBrian

Replies: 5
Views: 9176
Last post December 29, 2008, 09:03:25 PM
by TechnicianBrian
Whirlpool Oven E1 F2 Error

Started by TechnicianBrian

Replies: 0
Views: 14047
Last post July 11, 2008, 07:59:01 AM
by TechnicianBrian
Kitchenaid Range F1 E6 Error

Started by TechnicianBrian

Replies: 0
Views: 3447
Last post August 19, 2008, 06:46:27 AM
by TechnicianBrian
Whirlpool Microwave F2Q1 Error Message

Started by TechnicianBrian

Replies: 0
Views: 2712
Last post September 17, 2008, 07:24:01 AM
by TechnicianBrian