This Frigidaire GLTF1040AS0
washer begins the cycle by filling, then justs tumbles clockwise and counterclockwise until the cycle ends and the end of cycle buzzer goes off.
I followed the "Drive Motor Tumbles very slowly in any timer position" portion of the troubleshooting guide and measured 185.3 Ohms between pins 3&4 of the 10 pin plug. That reading, I thought, led me to the defective speed control board branch, so off I went to purchase a new board.
I installed the board with the same result. I then looked at the "Drive motor tumbles but does not spin" portion and measured voltages on spin: pin 1 34.2, pin 2 35.3, pin 6 122.1, pin 9 37, pin 10, 34.6. This showed a defective timer....
So, I can return the speed control board (20% restock), but want to know if you think the timer will fix my issue.....or am not reading the charts correctly?
What other troubleshooting steps can you suggest to isolate the issue?
Thanks in advance.