Frigidiare Kenmore Front Load Washer Inner Tub & Tub Bearing Replacement.

[AJ]

Check out the attached pdf file for step by step instructions.

[BrntToast]

done a bit different than we do em, but congrats on the ingenuity

i'll have to find a customer that will record me doin one for you, i can cut that time to 2 hours
if your not including the time it takes me to press in the new rear bearing, cause we do them on a rebuild basis, i take the old rear shell if not damaged as a core, if it was damaged they pay core too

on average a rear shell/inner basket takes me 1.5 hrs on concreate floor, 2 hours if i have to play with plywood to protect flooring

[Repair-man]

After seeing the hassle of taking the boot off, etc. is it not possible to skip that part and just separate the 2 halves leaving the boot and front weights in place? Admittedly, it would be heavier, but less trouble to re-assemble and fewer steps in the repair.

If I am missing something, please let me know. I have not done one of these yet. (I can do the Neptune outer tub and spinner support replacement in under 1 hour)

[AJ]

done a bit different than we do em, but congrats on the ingenuity

I should note, these are not my photos or even my pdf file.
I got it online someplace long ago. Don't remember were.

If anyone would know I sure would be happy to give the creator credit.

[AJ]

i'll have to find a customer that will record me doin one for you,

That would be awesome!

[BrntToast]

thats where i do them different, i remove the boot from the front of the cabinet(older machines its crazy glued on and requires a carefull hand and sharp flexable blade)

with the tub boot removed front the front of the cabinet you then lay the machine on its back and lift the cabinet off the tub assembly