Author Topic: Maytag Neptune still won't spin after replacing 2 parts  (Read 1296 times)

Offline krudd

  • VIP Member
  • Member Since: Apr 2010
  • Posts: 1
Maytag Neptune still won't spin after replacing 2 parts
« on: April 09, 2010, 12:02:52 PM »
 >:(  Ok, after doing some WEB research I came across an old post from here on a Maytag Neptune MAH4000AWW that wouldn't spin.  I purchased the recommended parts - Control board and Wax Motor - and replaced them.  The picture of the control board posted looked just like the one we took out.  (Burned R11)  

So now what?  We took off the back panel to make sure the belt was ok - yes.  Does the motor have a capaciter?  If yes, can it go bad and cause the no spin problem?

Help!

Model MAH4000AWW

 

Maytag Neptune MAH4000AWW - No Spin.

Started by larry

Replies: 39
Views: 57439
Last post February 21, 2011, 01:22:14 PM
by bwhelan
Maytag Neptune Washer - No Spin

Started by AJ

Replies: 6
Views: 5153
Last post February 20, 2008, 12:41:13 PM
by AJ
Maytag Neptune Mah4000aww will not go through cycles or spin...

Started by Mudd222

Replies: 11
Views: 4218
Last post April 23, 2013, 11:14:30 AM
by def
Maytag Neptune Very Noisy During Spin

Started by TechnicianBrian

Replies: 0
Views: 2889
Last post April 24, 2008, 10:14:55 PM
by TechnicianBrian
Maytag Neptune Washer - LR on display and no spin

Started by AJ

Replies: 0
Views: 4135
Last post May 05, 2008, 07:00:37 PM
by AJ
Maytag Neptune MAH4000AWW burning smell during spin cycle.

Started by ksujason

Replies: 15
Views: 16459
Last post September 14, 2008, 11:46:31 PM
by Repair-man