Whirlpool Washer noise

[brad]

Have a Whirlpool washer that is making a loud grinding noise at the end of the spin cycle.Sometimes it sounds like it is slamming to a stop.I have removed the case and got down to listen to it and it doesn't sound like it is coming from the bake ,but from above the brake.I have also removed the agitator and ran it, and it still makes the noise.What could this be?Where do I go from here? The model no is WTW5200SQ0.

[brad]

After re-checking I thing now that it is in the brake.Do any of you guys have any info or experiance on this kind of problem,or can offer any tips?

[Earl Dryer]

Brad, I have seen several washers lately where the tub drive block has become worn and the centrifical force tries to keep the tub spinning but it has a sloppy stop and the tub block tries to jump over the ears on drive tube.  Remove the agitator and the white nylon
piece from the agitator shaft, do you see any aluminum shaving or dust? Next put the washer in spin with a screwdriver depress the lid switch and let the machine spin for a few seconds watch the tub block (area between the big nut) and see if you notice any slop in the block and drive when you release the lid switch and the basket comes to a stop, if so you may be able to replace just the tub block if the leading edge of drive tabs are not damaged. 

[brad]

Thanks so much for the info I'll going to do as you suggest.Thanks again

[brad]

Ok I  checked as per what you said.And you were right on it,that is where the noise is coming from.I removed the big nut from the top and there is no tabs on the drive shaft,when it stops the shaft makes a grinding noise as it comes to a stop.How hard is it to change out this thing?

[Earl Dryer]

If the 2 tabs on the tub drive are gone, you will have to replace the tub drive sleeve & brake assembly + tub block.   1st remove the cabinet and tub, tip the washer back, remove the pump & motor, remove the 3 bolt that hold the transmission in place and the trany out, next turn the plastic clutch paw to releave pressure on the brake & pull down & out, Replace the whole Brake assy & Tube it also comes with a new clutch. Don't forget to replace the block. It is pretty simple. If you need some video help summons my main Man on this JW Webster he is a great help and has a wonderful video collection.

[brad]

Thank you so much for this great info.

[JWWebster]

Direct drive repair videos and manuals

[brad]

Thanks JW for the info,I've replaced the drive block and nut and now all is good,machine working like a new one.Thanks to uou guys and this site.