Had the dancing washer problem and replaced the snubber last night.
This took care of 90% of the problem. However I notice that the tub starts leaning towards front right (and shakes a little) once the spin cycle starts - no matter what size load or how heavy the load. There does come a point when the washer will start dancing again based on the size of the load. I leveled the machine and this helped some but the tub keeps leaning towards front right once it starts spinning. I actually centered the tub manually when it was spinning & it immediately resumed the leaning position once I removed my hand. All springs were re-installed so that isn't the problem. Also noticed that when it comes to a stop it sometimes assumes the right front lean position even when empty.
Looking for suggestions on how to stop the tub from leaning