Author Topic: trouble getting cabinet to stay on  (Read 898 times)

Offline viking351

  • VIP Member
  • Member Since: Jan 2009
  • Posts: 152
  • Country: us
trouble getting cabinet to stay on
« on: March 17, 2010, 07:35:48 PM »
after a repair on this unit when i went to put the cabinet back on it would not "Hook" into the TAB on the bottom left rail because the tab had broke off. anybody else ever experience this problem? any suggestions?

Model kaws577eq0

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8781
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: trouble getting cabinet to stay on
« Reply #1 on: March 17, 2010, 07:47:07 PM »
Them cabinets are tricky to be sure. I always open the lid so I can look down at the base and get it close. Then give it kick to settle it in and make sure I do not pinch the water level hose. Have you seen this video:
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

 

Video: How to remove the cabinet from a whirlpool direct drive washer

Started by AJ

Replies: 0
Views: 3973
Last post January 09, 2008, 06:21:03 PM
by AJ
Thong trouble

Started by nivard

Replies: 8
Views: 3097
Last post May 06, 2008, 09:06:15 AM
by JWWebster
Maytag Washer, Trouble filling??

Started by Joshuajared

Replies: 11
Views: 6473
Last post September 24, 2008, 01:40:48 PM
by Repair-man
Open Cabinet

Started by ridgetop

Replies: 1
Views: 1526
Last post December 27, 2008, 03:56:55 PM
by ridgetop
how to remove cabinet on stackable whirlpool washer

Started by hoghunter

Replies: 3
Views: 4824
Last post June 29, 2009, 11:46:25 AM
by JWWebster
neptune trouble with washing other than cold

Started by christacy

Replies: 1
Views: 1104
Last post September 28, 2009, 07:44:15 AM
by Repair-man