Forum > Washer Repair

Whirlpool washer won't fill

<< < (2/2)

e.p.:
I just looked at the manual and its not exactly right as far as the controls are concerned. This washer has a load sense control p/n W10177795 and an atc control p/n W10179666 and a flow meter. I need to know how to trouble shoot these controls.
Thanks.

JWWebster:
The down spout has 2 orange wires attached with a thermister. You could at least check that for continuity. The washer has a automatic temp control and 3 inlet valves. I worked on one last friday. Inlet valve had the top solenoid open.

e.p.:
Hi;
Thanks for the replies. The thermister is reading ok. When I took it apart there was one wire off it but I put it back on but it still wouldn't work. There are only two solenoids on this machine and if I energize them externally I can get water to flow. After the outlet of the valve there is a flow meter in the line. Does anyone know how this part is supposed to work??
Thanks.

JWWebster:
That would be the water temp switch

Navigation

[0] Message Index

[*] Previous page

Go to full version