Author Topic: Maytag performa spinning out!  (Read 16754 times)

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Maytag performa spinning out!
« Reply #30 on: April 13, 2008, 02:16:50 PM »
Just one note on the Performa (Atlantis too), if a load gets off balance, the tub will not spin but a couple of turns a second. There's an automatic braking response if the tub travels too far near the cabinet. Be sure you always use the HIgh water levels, even with smaller loads to avoid having the load bunch up on one side of the spin basket.

Also, check to see that your pump is discharging a full tub of water in under 70 seconds. If not, you have pump issues. To find out, fill the machine to a high water level, then switch the timer over to a spin cycle and time the discharge until the tub is empty.
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Maytag performa spinning out!
« Reply #31 on: April 13, 2008, 03:21:14 PM »
Is it working now?
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline lowhook

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 49
Re: Maytag performa spinning out!
« Reply #32 on: June 11, 2008, 06:40:42 PM »
I filled the tub to the max with no cloths in it and it took 2 min 10 seconds to empty it

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Maytag performa spinning out!
« Reply #33 on: June 11, 2008, 07:46:44 PM »
Take the pump apart and get the gookus out of it.


Maytag Performa Washer Drain Pump Part # 35-6780
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline lowhook

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 49
Re: Maytag performa spinning out!
« Reply #34 on: June 11, 2008, 08:11:16 PM »
Did that ,nothing in it ,impeller looks clean and spins freely. Bearing feels tight . I'm going to take it to the local repair man tomorrow have him loom at the pump see if he see's anything wrong with it.

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Maytag performa spinning out!
« Reply #35 on: June 11, 2008, 09:04:15 PM »
Yeah, take it to the repair guy. He'll likely replace the pump. Or save yourself a few steps and go get the pump and install it.
It's part # 35-6780

Remember my first post?
Quote
check to see that your pump is discharging a full tub of water in under 70 seconds. If not, you have pump issues

Maytag has improved the pump since your machine was made .
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline doobsdad

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 2
Re: Maytag performa spinning out!
« Reply #36 on: July 05, 2009, 07:49:23 PM »
This was helpful, but I have a tidbit to add.  I was having the same problem.  Maytag Performa PAV5000AWW.  Clothes sopping wet. Then I noticed it agitated but did not spin.  I finally tried replacing the thrust bearing kit, which went ok, but I also had a hard time getting that last, thin washer on before the final E-clip.  The adjustment indicator was just below "minimum".  I followed the advice here and got the washer on, but it made it WORSE--way below minimum.  So I tried the old, worn cam (I think--the white plastic piece that goes into the pulley right before the last washer and e clip).  I did not place any washer, and now the indicator is between min. and max. and lo and behold, it works!  Hallelujah.  I am a little worried about not having a washer, but hey, it works.

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Maytag performa spinning out!
« Reply #37 on: July 06, 2009, 06:17:44 PM »
Glad ya could Get ER Done! That is a tough job for a novice. It is a trial and error thing to get that just right. If you have too many washers then the drum will not lock inplace for wash and the clothes will knot up. If you do not have enough then it won't spin. ya dun good!!!
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline doobsdad

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 2
Re: Maytag performa spinning out!
« Reply #38 on: July 07, 2009, 11:05:44 PM »
Thanks.  I'm a novice, like you said, but are you sure it isn't the other way around?  It seemed I needed fewer washers for the brake to release.

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Maytag performa spinning out!
« Reply #39 on: July 07, 2009, 11:13:44 PM »
All I know is: :D the dayum thang is wurkin. If it ain't right it wont wurk!
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

 

Maytag Performa Pav2300aww Not Spinning please help

Started by slm28638

Replies: 2
Views: 7001
Last post June 29, 2009, 11:06:36 AM
by JWWebster
maytag performa out of balance

Started by mechemd1

Replies: 1
Views: 2455
Last post December 31, 2007, 06:47:41 PM
by AJ
Maytag Performa Washer will fill (after changing snubber) but will not agitate

Started by PD

Replies: 10
Views: 8664
Last post January 01, 2008, 05:14:06 PM
by AJ
Maytag Performa This forum helped me. Thanks

Started by ArnieTX

Replies: 5
Views: 3629
Last post January 22, 2008, 07:33:08 PM
by ArnieTX
Maytag Performa Won't Spin

Started by matthewdurango

Replies: 4
Views: 4454
Last post February 03, 2008, 02:36:16 PM
by JWWebster
16023083 Maytag Performa Washers Service Manual

Started by whirlpooltech

Replies: 0
Views: 4912
Last post March 22, 2008, 07:54:25 PM
by whirlpooltech