Whirlpool Electric Dryer - Start button won't work

Total Members: 6314

Total Posts: 29029

Welcome, Guest. Please login or register.
Did you miss your activation email?
July 29, 2010, 09:20:12 PM

ApplianceJunk.com - Your Appliance Repair Experts! > Do-It-Yourself Appliance Repair > Whirlpool Appliance Repair > Whirlpool Electric Dryer - Start button won't work

Pages: [1] Go Down

« previous next »

	Author	Topic: Whirlpool Electric Dryer - Start button won't work (Read 939 times)
0 Members and 1 Guest are viewing this topic.

inthecity

Rookie DIYer

Karma: +0/-0
Offline

Offline

United States

Posts: 3
Referrals: 0

Whirlpool Electric Dryer - Start button won't work
GEW9868Kq2

« on: January 26, 2010, 11:16:57 PM »

All of a sudden my whirlpool electric dryer start and stop/cancel buttons dont work.
1) I tried the Test mode, More time/less time in 5 seconds... all light up and display shows 88. I hit stop/cancel the unit goes out of test mode as expected.
2) When I open the door there is no light in the drum.
3) When I hit any of the wash cycle buttons (Normal/Delicate/etc). control panel lights up and shows the estimated time for drying.

However the start button does not work after that. If I try to cancel out the Stop/Cancel button does not work either, control panel just stays lit.

I verified that I am getting 120v on each of the live prongs with a Multimeter.

Please help what to look next


	Logged

JWWebster

Technician

Karma: +320/-10

Online

United States

Posts: 4905
Referrals: 89

Re: Whirlpool Electric Dryer - Start button won't work
GEW9868Kq2

« Reply #1 on: January 26, 2010, 11:27:26 PM »

Drop the kick panel and check all the safety's you can. I suspect you have a blown duct fuse.


	Logged

May the hinges of our friendship
never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email and I wish I knowed how to do IM's without the IM lizards that pop up. Very annoying.

inthecity

Rookie DIYer

Karma: +0/-0
Offline

Offline

United States

Posts: 3
Referrals: 0

Re: Whirlpool Electric Dryer - Start button won't work
GEW9868Kq2

« Reply #2 on: February 08, 2010, 06:53:31 PM »

I checked the Thermal cutoff, thermostat and the Thermal duct fuse. All of them checked out ok.

When i physically disconnect the power for some time and plug it back in the dryer worked. I had this going for a couple weeks.

Now all of the sudden non of the lights on the control panel work.. Its totally dead. Any ideas what may be the issue


	Logged

JWWebster

Technician

Karma: +320/-10

Online

United States

Posts: 4905
Referrals: 89

Re: Whirlpool Electric Dryer - Start button won't work
GEW9868Kq2

« Reply #3 on: February 09, 2010, 02:57:25 AM »

Could a loose connection. Check the receptacle and the power cord connections


	Logged

Repair-man

Technician

Karma: +283/-6

Online

United States

Posts: 2904
Referrals: 4

Re: Whirlpool Electric Dryer - Start button won't work
GEW9868Kq2

« Reply #4 on: February 09, 2010, 07:13:40 AM »

Have a close look at the main PCB. This sounds like an intermittent problem associated with a loose solder connection or a failing component of the board. Be sure this unit is well grounded and that there is not a low-voltage condition existing on the dryer circuit.


« Last Edit: February 09, 2010, 07:21:38 AM by Repair-man »	Logged

"It's only expensive if someone else fixes it for you" -
The Virtual Repairman www.repair2000.com

JWWebster

Technician

Karma: +320/-10

Online

United States

Posts: 4905
Referrals: 89

Re: Whirlpool Electric Dryer - Start button won't work
GEW9868Kq2

« Reply #5 on: February 09, 2010, 01:12:21 PM »

Did you remove the 2 screws that hold the filter housing and check that pesky duct fuse?
This movies shows the dryer duct fuse after the guy removes the filter housing:

Dryer breakdown

3390719 fuse.jpg (5.8 KB, 120x94 - viewed 236 times.)
	Logged

inthecity

Rookie DIYer

Karma: +0/-0
Offline

Offline

United States

Posts: 3
Referrals: 0

Re: Whirlpool Electric Dryer - Start button won't work
GEW9868Kq2

« Reply #6 on: February 09, 2010, 03:28:04 PM »

I did check remove the 2 screws for the duct panel and checked the duct fuse with a mutimeter. it shows continuity. If it was the duct fuse, i would think the control panel should still light up though.. even if the start/stop dont work


	Logged

Pages: [1] Go Up

« previous next »

Search Forum