Author Topic: Agitator shaft agitated.  (Read 1489 times)

Offline dwhite65

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 3
Agitator shaft agitated.
« on: February 25, 2008, 09:23:36 AM »
While removing the inner basket I got a little over zealous:tickedoff:.  I could figure out why the inner basket would not come out even  seal nut removed  :thinking:.  I messed up :oops: and channel locked the threads on the shaft thinking something there needed to come out.  Any ideas on how to fix or get around this.  They are not to bad ( I hope) but I'm sure the nylon threads on the shaft seal will not with stand and seal against it.

Model MAV6357

Offline MajorApp

  • Technician
  • Member Since: Feb 2008
  • Posts: 539
  • Country: us
Re: Agitator shaft agitated.
« Reply #1 on: February 25, 2008, 03:19:54 PM »
hey, your not the first person to ding up some threads. you will have to get a die that matches the threads on the shaft and turn that all the way on to straighten the threads. then use a fine file and sandpaper to smooth any burrs left on the threads. you might need to find repair manual to get the right die so it matches the threads on the shaft unless you have a thread gauge.

Offline dwhite65

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 3
Re: Agitator shaft agitated.
« Reply #2 on: February 26, 2008, 10:07:28 AM »
Thanks for the come back Majorapps :tiphat:.  Does anyone out there know the correct die size for the shaft :thinking:.  It's not listed in the manual :bonk:.  If not I'll find out when the shaft seal comes in.  It's a little easier to carry than the transmission is :banana:.

 

Need advice on Maytag agitator shaft being hot.

Started by traperto

Replies: 0
Views: 1055
Last post May 14, 2009, 04:40:40 PM
by traperto
Video: How to replace the "Dogs" in your Whirlpool washer agitator.

Started by AJ

Replies: 1
Views: 9415
Last post May 25, 2008, 11:09:16 PM
by jean
agitator not spinning

Started by whit

Replies: 2
Views: 2137
Last post October 22, 2007, 06:21:57 PM
by Pegi
Whirlpool washer LSQ9010KQ0...Can't seperate Agitator

Started by Matt F.

Replies: 5
Views: 3576
Last post December 16, 2007, 06:09:05 PM
by AJ
Agitator only spins one way

Started by will_m

Replies: 2
Views: 2981
Last post February 20, 2008, 06:00:55 PM
by will_m
Input Shaft Oil Seal Kit

Started by jennidoug96

Replies: 3
Views: 2250
Last post June 24, 2008, 09:28:27 PM
by JWWebster