Author Topic: Kenmore side by side frig ice issues  (Read 1778 times)

Offline scooter88

  • VIP Member
  • Member Since: Dec 2009
  • Posts: 1
Kenmore side by side frig ice issues
« on: December 27, 2009, 06:17:05 PM »
Hi, I have tried to troubleshoot this ice maker for a couple of weeks now. Cleaned the optical sensors, made sure water tube wasn't frozen up, replaced water valve (which wasn't the problem). Can't figure out why ice making is so sporatic and cubes are funny shaped, almost like the cubes freeze while the arms to kick the cubes out are in the down position, (cubes have holes in them where the arms were). could the ice maker be "out of time" and not following the correct sequence?
Any info would be greatly appreciated!

Model 106.56546400

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Kenmore side by side frig ice issues
« Reply #1 on: December 27, 2009, 06:33:40 PM »
There is a hi-torque module kit for this unit which should solve the problem. It comes with a new ejector as well.
WP Part # 626653
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

 

106.52552.100 Kenmore side by side ice maker issues

Started by Ufers5

Replies: 16
Views: 1735
Last post December 28, 2012, 02:22:29 PM
by Ufers5
Kenmore side by side, water tastes terrible

Started by 2kcloudy

Replies: 4
Views: 2982
Last post July 19, 2008, 04:28:56 PM
by RegUS_PatOff
Kenmore side by side-ice door flap?

Started by Jearls2

Replies: 2
Views: 1759
Last post October 08, 2008, 09:26:40 PM
by JWWebster
Kenmore 106.56539400 Side By Side Not Cooling?

Started by shacky001

Replies: 6
Views: 3187
Last post October 09, 2008, 02:14:49 PM
by JWWebster
KitchenAid Side by SIde Ice Dispenser issues and water

Started by santarosa

Replies: 6
Views: 5495
Last post October 23, 2008, 03:22:29 PM
by santarosa
106.5666502 Kenmore side-by-side copper corrosion

Started by josraclee

Replies: 1
Views: 1187
Last post November 10, 2008, 06:57:06 PM
by JWWebster