Forum > Washer Repair

maytag atlantis washing machine problems

<< < (2/2)

JWWebster:
I bet your molex block is loose. Thats the electrical connection that shoves into the timer. Remove it and clean the contacts of corrosion. Put it back in that timer. Make sure it is tight up against the timer.

jumptrout51:
Did it start agitating before it was full,or did it fill first?

kkmarrs:
Thanks I will check the connections and clean. What should I clean the connections with?

It had filled up like normal then starting agitating like normal. I have run two loads with no problems so far. Wish me luck.

JWWebster:
use contact cleaner

apprich:
To clean electrical contacts, I use CRC non-residue contact cleaner available at Low's

Navigation

[0] Message Index

[*] Previous page

Go to full version