Can you tell me where I can locate this special compression tool. I would like to see this so I might understand how it would help with this application. Also there isn't any screws in the brake assembly (item#433674), I did see in the service manual under Brake Disassembly where they show these screws, but this has been changed instead they have crimped the edges over in eight places and removed the screws from the part. In the service manual they do not mention this tool when installing the brake assembly. It reads #1 Place redial bearing in top of brake package. #2 Insert brake over drive tube splines. #3 Start threads of brake package into damper turning it by hand. #4 Be sure that tub block is in place keeping tubs level so as to prevent binding on brake package threads. #5 When turning brake package into the damper, allow power unit to turn so that you do not have to overcome the friction of the brake. #6 When treaded tight, use the brake tool and hammer to seat brake package firmly in place. #7 Locate retaining clip and tighten damper bolt securely into damper. Note: Once the brake has been reinstalled, turn the pulley on the shaft until the brake is disengaged. With the brake disengaged, the oil will run into the brake package. Turn the pulley several times to insure proper lubrication.