Author Topic: Maytag LAT9356AAE Spin problem  (Read 3894 times)

Offline Camarocam

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 2
Maytag LAT9356AAE Spin problem
« on: February 18, 2008, 11:12:02 AM »
  My washer will not go into the spin cycle, it spins but not at like a normal wash speed not quickly enough to dry the clothes. It worked fine before I replaced the driveshaft seal? The trasmisson spins just very slow. I looked at the bottom where the pulley is, it spins fast no slipping of the belt but if I push the motor in on the slid its like the transmission switchs gears because then the trans speeds up and the bottom pulley slows down but still not as fast as it should be?

Model LAT9356AAE

Offline AJ

  • Technician
    Administrator
  • Member Since: Jun 2007
  • Posts: 9249
  • Country: us
    • ApplianceJunk.com - Appliance Repair Help
Re: Maytag LAT9356AAE Spin problem
« Reply #1 on: February 19, 2008, 11:06:24 AM »
Hi,

Have you tried a new belt?


Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Maytag LAT9356AAE Spin problem
« Reply #2 on: February 20, 2008, 10:10:40 AM »
Apparently somewhere in your repair process, the spin bearings are binding.

1.To what extent did you tear down the machine?

2. Did you have  cause to remove the large drive pulley on bottom for any reason?
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

 

Maytag Washer Spin & Drain Problem

Started by lulubovary

Replies: 1
Views: 2199
Last post March 11, 2008, 04:43:09 PM
by Repair-man
Maytag Performa spin problem

Started by chrismorrow02

Replies: 3
Views: 5950
Last post December 15, 2008, 07:21:33 PM
by Repair-man
Maytag Neptune Spin Problem/Contoller board not burnt

Started by sdocsmith

Replies: 3
Views: 1623
Last post January 08, 2009, 02:52:28 PM
by whirlpooltech
maytag neptune stackable slow spin no drain problem

Started by kellonnie

Replies: 0
Views: 1308
Last post November 11, 2009, 08:56:12 AM
by kellonnie
Maytag washer spin problem

Started by Bill

Replies: 4
Views: 1723
Last post February 03, 2011, 05:17:20 PM
by JWWebster
maytag spin problem

Started by batgrl87

Replies: 2
Views: 1180
Last post February 03, 2011, 05:20:09 PM
by JWWebster