from a friggy service letter
Not all of the detergent is being washed out of the dispenser, or the consumer is using detergent
tabs and they are getting stuck in the dispenser.
The roller assemblies for the lower rack have been redesigned, lowering the rack by ½”, allowing
clearance for the detergent dispenser door to open farther. The service kit number is
p/n 154573401. It comes with four wheel assemblies and installation instructions.
to test proper fill
Select a cycle and time the fill. The fill time will be 87 seconds for each fill. Once the wash
motor has started, open the door and check the water level. With the dishwasher level; the
water should come to where the heater mounting clips attach to the tub.
if you have an optional rack that clips on to the bottom rack on the left hand side near the detergent cup... remove it and try machine without this raised left side rack
also... determine if the door is sticking on the top or bottom rack, you can figure this out by runing a short wash with no bottom rack
if you hear the cup door snap open when you open the d/w door with no bottom rack then you know it is catching on the top rack