Author Topic: Lint duct to blower removal  (Read 2688 times)

Offline ebinc

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
Re: Lint duct to blower removal
« Reply #10 on: October 19, 2009, 07:05:12 PM »
OK saying yank out the wires might not have been a very good way to explain it.
Of course you would never grab the wires but the connectors or the spade clips.
It might a good Idea to wear latex gloves with these newer machines to prevent static discharge from affecting these lame mexitronix. LOL

Really sorry about the big production over something so simple to do, Just got it,
a big paper clip was lodged near the blower exhaust opening at the top, there is a nice
scrape trail in the plastic under the blower blades

I bet that door switch is a very popular item at the parts dealer those spades are really
on their and that switch is so chincy but I really went gentle as possible taken them off
made sure the blower duct and front panel seal sat just right.

I don't think it's possible for them to make these dryers any cheaper they didn't even
waste the electrical tape going up properly for the harness as it entered the control panel

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8781
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Lint duct to blower removal
« Reply #11 on: October 19, 2009, 07:43:41 PM »
glad ye could git er dun!!!
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

 

Video: How to take your Whirlpool dryer apart to replace parts & remove lint

Started by AJ

Replies: 0
Views: 21931
Last post August 16, 2007, 06:02:43 PM
by AJ
Myth Buster #1 Re: Dryer Lint Screens

Started by Repair-man

Replies: 3
Views: 2560
Last post March 11, 2008, 09:45:09 PM
by JWWebster
lint shute

Started by diyguy

Replies: 3
Views: 1630
Last post October 18, 2008, 02:51:05 PM
by diyguy
I need to remove the blower in order to change motor

Started by jpococke

Replies: 2
Views: 1537
Last post October 23, 2008, 09:02:01 PM
by JWWebster
Kenmore Dryer Discontinued Wheel Blower

Started by Trav13

Replies: 9
Views: 3461
Last post January 23, 2009, 11:03:53 PM
by AJ
lint accumulation

Started by jackiej

Replies: 1
Views: 1648
Last post April 01, 2009, 04:36:12 PM
by Repair-man