About two weeks ago I replaced the boot seal, and tub bearing in my Maytag washer and then the belts. After the repair, everything was fine for about a week or so. Now there is a puddle of water under the washer after each load. The puddle is about the size of the bottom of the washer and then a trail goes to the drain. I'd say that it's about a gallon of water total.
I did verify the tightness of the hose clamps. The hoses did look good. When I pulled the drum out for the boot seal and tub bearing, I reused the rubber seals that go over the bolt heads, but they looked okay. The inner and outer drum are both essentially rust free.
The machine runs quiet and does not shake. Unlike previously, now there is no tell-tale trail of lube sprayed on the inside of the cabinet, so I'm assuming that my boot seal is okay still.
Any tips on where to look for my leak?