Author Topic: LG Dryer Noisy  (Read 7371 times)

Offline cindid

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
LG Dryer Noisy
« on: October 01, 2009, 12:49:41 AM »
We purchased this LG DLG9588WM  dryer along with LG Tromm WM2496HWM Washer around February I think of 2007.  We have already replaced the washer due to the fact it could not get our clothes clean and kept finding sludge in agitator arms with balls on the inside even though we followed the tub clean recommendations.  Now right after replacing the washer the Dryer started to make sounds like a pair shoes are in there.  I really would love to replace the dryer too but can't really afford to right now.  We also have what appears to be rust on the back part of the drum where the holes are.  Is there an available service manual yet for this model?

Thank you,
 Cindi

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: LG
« Reply #1 on: October 01, 2009, 07:25:03 AM »
LG doesn't list this particular model on their website yet, but a similar model is, and the manual link is shown below. The mechanical similarities to your model should be identical. Sounds like you need a new drum. If yours has a stainless steel drium, it is warranted for life.

Service Manual
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline cindid

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
Re: LG
« Reply #2 on: October 01, 2009, 04:25:21 PM »
Thank you,

So the thumping could also be caused by the drum?  Or is that separate from the rust issue?  Thank you for the manual.

Cindi

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: LG
« Reply #3 on: October 01, 2009, 04:49:48 PM »
Hi Cindi;

The thumping is usually caused by a split seam  in the drum, as they are rolled into a round shape, then tack-welded. The rust is just a secondary failure.
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline cindid

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
Re: LG
« Reply #4 on: October 01, 2009, 06:21:02 PM »
Where would the split occur can you see it with just top off or do have to remove front or back panel to see it?

Thank you so much for your help.

Cindi

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: LG
« Reply #5 on: October 01, 2009, 06:22:52 PM »
With the top off, rotate the drum by hand until the welded seam appears in view. Chances are it has a gap somewhere that causes the clunking sound as it passes over the rollers.
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline cindid

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
Re: LG
« Reply #6 on: October 01, 2009, 06:28:19 PM »
Thank you! I will go check that!

Cindi

Offline cindid

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
Re: LG
« Reply #7 on: October 01, 2009, 06:35:33 PM »
I do not see a visible gap in the seam.  The sound appears to be coming from the front when I rotate the drum by hand.  Could it be flat roller or something like that? Or could the felt be interfering with me seeing the gap?

Cindi

Offline cindid

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
Re: LG
« Reply #8 on: October 04, 2009, 02:46:40 AM »
Getting louder no split seam! ?

Cindi

Offline RegUS_PatOff

  • Technician
  • Member Since: Dec 2007
  • Posts: 1410
  • Country: us
Re: LG
« Reply #9 on: October 04, 2009, 03:37:49 AM »
could be the Rollers ...
After leaving this Earth, "Do you want the smoking or non-smoking section?"

Offline cindid

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
Re: LG
« Reply #10 on: October 04, 2009, 05:50:27 PM »
Here is the actual service manual in case someone else needs it.  It appears to be pretty much the same as the one you said would be.

http://www.appliancefactoryparts.com/content/pdfs/125400.pdf

Not sure if I posted it right.

Cindi

Offline cindid

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
Re: LG
« Reply #11 on: October 05, 2009, 11:50:27 PM »
Not just a flat roller a busted roller from the center out.  I am going to try to get a pick of it to upload.  I have never had these kind of problems with dryers in the past.  This dryer is only 2 years old. ridiculous!

Cindi

Offline krazytech

  • Technician
  • Member Since: Sep 2007
  • Posts: 705
  • Country: us
    • Buy me a beer through paypal
Re: LG
« Reply #12 on: October 06, 2009, 12:04:41 AM »
cindi I have seen rollers so bad .. That the harden steel axel was cut off.. I just wonder how long that dryer must have been making NOISE
Check the Basics first!!! Read the Manual !!!Buy the tech a Beer!!!

Offline cindid

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
Re: LG
« Reply #13 on: October 06, 2009, 01:01:30 AM »
It happened very quickly actually started with a squeak sound and within a couple days the loud noise started.  I noticed two front rollers so far is that correct? or is there a third?  I can see one back one without taking the back off yet.  The roller that went bad is the one in front just under the lint catch part of the drum.  The other front roller seems intake. Would you recommend replacing all or just the bad one? Also found it odd that if not a third roller how is it in balance? Oh well I will learn more as I disassemble it. What was really strange is it started right after having a new washer installed I know just fluke.  I am not liking LG products much at this point.  Are Whirlpool dryers good if and when I decide to replace the LG?

Cindi

Offline cindid

  • VIP Member
  • Member Since: Oct 2009
  • Posts: 29
Re: LG
« Reply #14 on: October 06, 2009, 01:28:23 AM »
Krazytech,

After looking at the service manual more closely looks like 2 front 2 back. 

Thanks,
Cindi

 

maytag neptune dryer is really noisy

Started by joy

Replies: 1
Views: 3276
Last post October 09, 2007, 07:43:45 AM
by AJ
Frigidaire Dryer - Very Noisy

Started by AJ

Replies: 0
Views: 2839
Last post January 14, 2008, 06:11:08 PM
by AJ
Noisy Frigidiare Dryer - Replace Rear Bearing.

Started by AJ

Replies: 3
Views: 5925
Last post March 31, 2008, 08:25:34 PM
by Al Capone
Maytag Dryer - Noisy

Started by AJ

Replies: 5
Views: 4479
Last post April 09, 2008, 11:04:44 AM
by JWWebster
Noisy Whirlpool LE7680XSW1 Dryer

Started by AJ

Replies: 0
Views: 659
Last post December 29, 2011, 04:14:27 PM
by AJ
Video: Noisy Whirlpool Dryer Drum Roller

Started by AJ

Replies: 0
Views: 689
Last post December 11, 2011, 10:39:42 AM
by AJ