I have checked the drain hose which is totally clear and have hotwired the drain pump which is working fine. The dishwasher does drain some during the cycle but leaves a couple of inches of water once the cycle is over. Cancel/Drain does not pump any water out. I am reading 15 ohms on the drain pump so I think the wiring harness is ok. Every thing else looks to be in order and float switch and water fill switch clean and working. The only thing I can think of is the control board which is less than six months old is bad. I did not run into any errors on the test mode.
What else could cause the drain pump to run for about two seconds and then stop? Is there anything I am missing?
Thanks in advance!