Ice maker not working

[c-ries]

I have a kitchenaid side by side and the icemaker quit working. There was no ice in the tray and the arm was stuck in the 6:00 position. I replaced the selinoid valve as has been the problem in the past with other units I have had, and tried to jump the motor. no luck. I have 120 voltage to the wiring harness, but no voltage between L and N. When the module was cold, I was getting continuity between L and N. I assume my module is fried, but I am looking for some confirmation. I did read other threads and got no voltage between T and H. Thank you for any help you can give me.

Model kscs25inss00

[JWWebster]

Check for voltage between T and H if you have 120 volts then the bi-metal (inside that ice mold thermostat) is bad. If it's good you will have 0 volts. Check THIS out

[c-ries]

I already checked for voltage between T and H. No voltage there.

[JWWebster]

If you have nothing between L and N you are not getting any power to the ice maker. Maybe that inline fuse on the IM wiring harness is open.

[JWWebster]

If you beleive you have 120 v going into the head of the IM but cannot jump between T and H and put the IM into motion then in my opinion that head is shot.

[c-ries]

Thanks for the confirmation. I think you are right about the module being shot. I do have continuity on either side of the inline fuse on the IM wire harness. Looks like it is time to buy a new module. May I say that I love this site. As a do-it-your-selfer, it is nice to have some direction as I muddle through things.

[JWWebster]

I just upgraded my ice maker page to show test points on a
 modular crescent ice maker.
Ice maker quit making ice