Author Topic: frigdaire stackable frontloader lights all lights light up no nothing  (Read 4590 times)

Offline problemsolver

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 8
girlfriends Frigidaire FTFB4000FS1 washer wont wash.. hard boot worked for a while. now same thing. logic tree? troubleshooting ? any help appreciated.

Offline BrntToast

  • VIP Member
  • Member Since: Nov 2007
  • Posts: 388
  • Mayday Appliance Service
    • frigidaire service blog
do the lights flash?
first thing to check is to make sure the child lock has not been activated... press and hold options and select button at the same time, hold for about 10 seconds

inside the machine is the mini-manual, it lists test procedures for common problems

is the tub full of water?
if you select drain/spin will the machine do anything?
« Last Edit: July 06, 2009, 08:55:42 PM by BrntToast »
Mayday Appliance Service
Winnipeg Manitoba Canada


The only stupid question is the one not asked

Offline problemsolver

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 8
my girlfriends daughter is with the machine she will be your eyes.
 

Offline problemsolver

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 8
This is the girlfriend's daughter..
I tried holding down the select and options buttons for 10 seconds and the lights flashed when the ten seconds were up. It didn't do anything other than what it usually does (the high, extra spin, cycle signal, wash, rinse, final spin, and a flashing start were all lit when pause/cancel was pressed).

It is not full of water.
Whenever I press spin it will just change to the choices high, medium, low, or no spin. That's all.


Offline BrntToast

  • VIP Member
  • Member Since: Nov 2007
  • Posts: 388
  • Mayday Appliance Service
    • frigidaire service blog
what if you turn the cycle knob to the drain/spin cycle and try to start the machine there?
Mayday Appliance Service
Winnipeg Manitoba Canada


The only stupid question is the one not asked

Offline problemsolver

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 8
Oh! haha, I didn't see that.
I switched it over to that and I tried to start it. The doorlock and final spin lights where on while the start was flashing. I pressed start and nothing happened?

Offline BrntToast

  • VIP Member
  • Member Since: Nov 2007
  • Posts: 388
  • Mayday Appliance Service
    • frigidaire service blog
the number of flashes gives error codes

http://cid-161d5dae096a24ce.skydrive.live.com/self.aspx/service%20manuals/frigidaire%20service%20manuals/frigidaire%20laundry/friggy%203.0%20cu%20elec%20washer.pdf

thats a link to the service manual for your machine, read the part about self-diagnostics and try them out

then post back results
Mayday Appliance Service
Winnipeg Manitoba Canada


The only stupid question is the one not asked

Offline problemsolver

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 8
My mother will have to get back with you tomorrow.
I can't find what I'm looking for.
Thank you for your help though.

Offline problemsolver

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 8
brntst you are the man!!! I dont care what they say about you and I'm sure youre not the fellow in the video. I'll run diagnostics on the machine with the girl baby tonight and tell you how it goes. Keep fixin the broke stuff and you will never grow old.  8) 

Offline problemsolver

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 8
Diagnostic test says to expect sequentially chasing, but the lights flash in unison instead of chasing.

 

LTF7000ES0 washer comes on starts then lights go off & after 15 secs on again

Started by jones0333

Replies: 2
Views: 1694
Last post November 19, 2009, 12:42:47 PM
by jones0333
Bosch SHX57C05UC-21, no lights on panel or display, washer inoperative

Started by berrytc

Replies: 4
Views: 2485
Last post November 17, 2010, 11:47:28 PM
by elite
dead no lights no beeps

Started by JPG

Replies: 3
Views: 1246
Last post April 14, 2011, 05:44:11 PM
by JPG
Kenmore HE2 no lights on control replaced ccu what's next?

Started by grs494

Replies: 8
Views: 1332
Last post April 18, 2013, 08:40:22 PM
by grs494
LG Tromm WM2688HWM all cycle lights are on, but won't let me choose.

Started by lgapplianceservice9

Replies: 4
Views: 839
Last post September 10, 2013, 05:22:22 PM
by lgapplianceservice9
Kenmore he2 blinking lights only spin cycle works

Started by Savemoney

Replies: 2
Views: 648
Last post January 14, 2014, 12:49:18 PM
by Savemoney