Kitchenaid KEBC107 Oven No Heat

[thepicker]

Hi,
 My kitchenaid oven stopped heating. The display just stays on LO.  It happened once before and then just started working after a day or two. The fan, lights, and everything else seems to be working fine.
    I tested the thermostat-thermofuse behind the panel on the back and it was closed(ohm meter showed a circuit).   The two red wires going to the lower heating element had no voltage. It's about a year old and has never been in self-clean mode.   Any advice would be helpful.
   the picker

Model Number: KEBC107KBL0

[RegUS_PatOff]

what's the letters and numbers after the model number ?

does the BROIL or CONVECTION heat work ?

[thepicker]

Hi,
  Thank you for the response. The full model number is KEBC107KLB.  I could not get heat from any mode.  I even tried dehydrate and bread raising modes.
  tom.

[RegUS_PatOff]

I couldn't find KEBC107KLB
 Could it be a KEBC107KBL ?

It could be a bad DOUBLE LINE BREAK RELAY (not on KEBC107KBL0)  on the electronic control board. The relays are not normally replaceable (unless you can solder and find a replacement).


Depending on which model you have:

You could test it by jumpering the CORRECT 2 RED wires on the control board.

The controller is part #4456033

[thepicker]

Hi,
 It is KEBC107KBL, my fault.
 Thanks a lot.  Does replacing the control panel  require soldering?
 thepicker

[RegUS_PatOff]

it shouldn't require soldering, the diagrams show all plug numbers, EXCEPT the (2) red wires to the DOUBLE BREAK RELAY (if equipped).

They may have to be soldered.

It may no longer be used on replacement control board.

compare your board to the pictures of the (newer) replacement board.

If you have one and the replacement doesn't use one, you MAY be able to bypass it.

It may be a safety disconnect incase one of the other heater relays stick. The new board MAY have better heater relays...