My junk Kenmore Model 110.21082000
(whirlpool) Calypso gave me the LD error 1 week ago (long drain). I took off the pump and noticed hair wrapped around the impeller and it looked like the teeth were stripped out of the top of it. I read online that they came out with a new design of pump and motor. I ordered it up and just installed it.
I began the cycle and the washer filled. As soon as it was supposed to nutate, nothing happened. I got the CE error (communications error). I reset and retried and got the LD error back.
So, I entered diagnostics mode and ran tests. I cannot get this thing to nutate. Since it won't enter that part of the cycle it won't recirculate. From the tests it seems that the pump is working. It just won't nutate or spin. I have it tipped back working underneath it and the overfill error pops up, I am assuming that is because I have it tipped.
Where should I start? I don't want to buy a motor now and have 2-300 into this POS or motor control board. Should I tear into the circuit board and test continuinty? I wonder why I fixed one problem only to have another problem form while I was fixing it.