Washer Walking on spin cycle

[Vernald]

I have the same washer walking (off-balance) on spin cycle - Inglis Washer.  The tub (drum? basket?) and the agitator sits on off-center angle when empty.  I replaced the spring that holds the drum steady....adjusted the washer legs...just replaced the broken motor coupler....replaced the agitator gasket...what else to do?

Model FWS235RFS6

[Al Capone]

Hi,

Please be sure to read, Posting Basics - Starting a New Topic.

Note were it say's towards the bottom.

Please do not ask your own question in a topic.
In other words, please don't hijack the topic and make it yours.
Start your own topic and reference the other topic related to your issue.

I have made your reply into a new topic.

[JWWebster]

you probably knocked it out of balance messing with that coupling.
Wiggle it around and run a few loads to get it back in sinc.

[Repair-man]

Inglis is the Euro label for Whirlpool appliances, so this is the standard direct-drive washer. More than likely, if you laid it over during your coupler repair, the tub support or "skate plate" could have been bent or warped, or possibly the snubber pads that are mounted on it have become worn out.

Skate Plate Kit

[Mr. Fix-It]

I did one of these yesterday where the skate plate was broken in 2. The first time I've seen that!! I've also seen where they just get out of proper position and just need to be realigned without replacing.