Author Topic: whirlpool dishwasher not draining water  (Read 8178 times)

Offline john kimble

  • VIP Member
  • Member Since: May 2009
  • Posts: 11
Re: whirlpool dishwasher not draining water
« Reply #15 on: May 22, 2009, 03:06:59 AM »
Quote
When you say the "hose from the garbage disposal", do you mean the hose that goes from the dishwasher -> sink overflow thing, or from the sink overflow -> garbage disposal? 

I'm thinking you are talking about a siphon break on the back rim of your sink. If it is, take the hose off coming from dishwasher and  if it's long enough, bypass the siphon break and hook it temporarily to the disposal. Try the drain again. It somehow sounds like a restriction on the washer side of siphon break. Itís worth a shot.


Well that worked!  So I guess all I need to do is buy a new siphon break?  I noticed with the hose direct to the garbage disposal I had to run the disposal or else it would slowly start to fill the sink.  Thanks again! 

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: whirlpool dishwasher not draining water
« Reply #16 on: May 22, 2009, 06:32:49 AM »
You also need a new garbage disposer....one that grinds up the food so that it does not back up the drain when the dishwasher discharges. You should not need a siphon break device at all as long as the drain hose can be raised higher than the discharge end at the disposer.
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline john kimble

  • VIP Member
  • Member Since: May 2009
  • Posts: 11
Re: whirlpool dishwasher not draining water
« Reply #17 on: May 22, 2009, 02:13:04 PM »
You also need a new garbage disposer....one that grinds up the food so that it does not back up the drain when the dishwasher discharges. You should not need a siphon break device at all as long as the drain hose can be raised higher than the discharge end at the disposer.

Well when I ran it like this to test it the drain hose was not much higher then the disposal...it was about level.  Im going to pick up a new siphon break and will keep you updated.

Thanks again

Offline john kimble

  • VIP Member
  • Member Since: May 2009
  • Posts: 11
Re: whirlpool dishwasher not draining water
« Reply #18 on: May 22, 2009, 03:19:28 PM »
Ok guys the new siphon break works. Dishwasher is back to 100%. The sink drains perfectly and does not overflow. Thanks a lot to all who helped.


Offline TJW

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 21
Re: whirlpool dishwasher not draining water
« Reply #19 on: May 23, 2009, 12:55:48 AM »
As far as a siphon break going bad, all I can relate to is the stem the hose from the washer goes to, collapsed where the clamp fastened to it. That made the passage so small water could barely get through, not to mention food particles from washer. Thereís easy ways around siphon breaks, but if you ever need one, youíll be glad itís there. Pick up a new one, but donít reef-down on the clamp too hard. On most, the stem is cheap plastic with warm water passing through.

 

Whirlpool Dishwasher - Does not pump the water out.

Started by AJ

Replies: 0
Views: 8783
Last post January 17, 2008, 10:34:53 PM
by AJ
whirlpool dishwasher wont spray water

Started by lsparkie

Replies: 17
Views: 12713
Last post April 28, 2014, 05:42:11 AM
by Laniktom
8193513A Whirlpool Dishwasher Water Pump & Motor Assembly

Started by AJ

Replies: 0
Views: 4144
Last post April 25, 2009, 01:41:13 PM
by AJ
8531670 Whirlpool Dishwasher Water Inlet Fill Valve

Started by AJ

Replies: 0
Views: 3868
Last post April 30, 2009, 11:49:32 PM
by AJ
8274220 Whirlpool Dishwasher Water Inlet Valve

Started by AJ

Replies: 0
Views: 3408
Last post July 01, 2009, 04:23:39 PM
by AJ
WHIRLPOOL QUIET PARTNER 3 DISHWASHER NOT DRAINING

Started by reamal2

Replies: 9
Views: 11728
Last post September 29, 2009, 07:16:03 AM
by Repair-man