Author Topic: Jen Air double oven replaced control panel - still having problems  (Read 1341 times)

Offline mikevalin

  • VIP Member
  • Member Since: May 2009
  • Posts: 1
I just replaced the control panel because the LCD panel would no longer show and the oven continually beeped.  After replacing the panel the oven still continues to beep and the word probe FLASHES on the LCD screen.   Does anyone know how to resolve this problem???
Many Thanks for any info you may have...
MV

Model WW27430P

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Be sure you plugged in all the harness wires correctly. If they are, the Probe light indicates that the board senses a temp probe in the socket. Generally running a selfclean cycle or over time, the temp probe jack gets little use, and the contacts can become corroded or oxidized. To remedy this, I usually have good luck by inserting the temp probe after spraying a dot of WD-40 into the hole. If you've never used the temp probe before, the jack is on the ceiling in the front left side of the oven cavity.

If you lost your temp probe or can't find it, any old guitar jack will do to exercise the contacts. Spray, then run the jack in and out a few times...in and out...in and , uh well, you get the picture.

This usually solves the resistance issue for the jack. Normally the two contacts are supposed to be closed unless the jack is plugged in. In extreme cases, I have had to replace the jack. The current part number for the jack (receptacle) is  74009649. It may be hard to find...


See Item #8 on This Diagram
« Last Edit: May 07, 2009, 09:39:40 PM by Repair-man »
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

 

control panel clock and oven will not work

Started by Pens Fan

Replies: 3
Views: 2060
Last post November 04, 2008, 06:38:02 PM
by Pens Fan
Built in Dbl Oven, Control Panel Zotzed

Started by Tinka

Replies: 5
Views: 3104
Last post November 10, 2008, 08:51:41 PM
by Tinka
8300441 Whirlpool Oven Control panel assy w/membrane, switch (white)

Started by AJ

Replies: 0
Views: 3512
Last post October 03, 2009, 02:58:45 PM
by AJ
Whirlpool double oven GBD277PDB09 locked after self clean cycle and blank panel

Started by aaronw112358

Replies: 23
Views: 8811
Last post April 04, 2010, 05:31:01 AM
by Repair-man
Maytag oven not reaching the correct temp, replaced the oven control board.

Started by Ol' Lonely

Replies: 0
Views: 595
Last post March 26, 2012, 09:45:17 AM
by Ol' Lonely
Replacing Control Board in Whirlpool Double Oven

Started by jennimac05

Replies: 10
Views: 2194
Last post July 05, 2012, 11:59:13 AM
by bigbuck