Author Topic: Maytag Dishwasher  (Read 3675 times)

Offline oneslowqb

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 6
Maytag Dishwasher
« on: April 25, 2009, 04:35:16 PM »
The unit went dead overnight. No power or lights. My lights came on 5 days later but the unit would not work. Lights went off again.  Cannot run system test. I replaced the main board but still no lights or power. Checked power hookup and all looks good. Thinking of changing out front touch pad but it s getting expensive. Any ideas out there? Thanks!

Model MDBH965AWB

Offline theoldstoveguy

  • Technician
  • Member Since: Jan 2008
  • Posts: 1334
  • Country: us
    • Buy me a beer through paypal
Re: Maytag Dishwasher
« Reply #1 on: April 25, 2009, 07:41:41 PM »
Check the wire connection where the cord connects..

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Maytag Dishwasher
« Reply #2 on: April 26, 2009, 06:56:01 AM »
This is the tall-tub model...

Take off the inner door panel and look carefully at the wiring harness where it goes down to the lower section. It will be pressed under a plastc retainer and goes under some foam insuation to the lower compartment.
I have had cases of broken wires there and the recommended fix is a new wiring harness, part # 99002986
« Last Edit: April 26, 2009, 06:58:44 AM by Repair-man »
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline oneslowqb

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 6
Re: Maytag Dishwasher
« Reply #3 on: April 26, 2009, 08:37:44 PM »
I had looked at the power connection ( It's hard wired)The ground was fine and no wires were burnt (I didn't take off the wire caps) . I checked the wire harness in the door where it enters the plastic clip, the wires look fine. It is a tall tub. I appreciate all of your help in trouble shooting this dishwasher. I'll  keep looking. Let me know if you think of something I am missing. Thanks again.

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Maytag Dishwasher
« Reply #4 on: April 27, 2009, 04:07:45 AM »
Ok, so if you did not take off the wire nuts, how do you know you have 120 volts to the unit???

The other likelihood is a failed door switch assembly, part # W10130695

You do have a meter, right?
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline oneslowqb

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 6
Re: Maytag Dishwasher
« Reply #5 on: April 28, 2009, 03:40:09 PM »
Tested the power, looks good. I'm thinking touchpad or door switch. 

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Maytag Dishwasher
« Reply #6 on: April 28, 2009, 04:07:45 PM »
You don't "think" a part is bad...you check it for continuity or for power going to it. "Thinking" can get you a lot of wasted parts :)

The touch pad is only a set of switches, easily checked with your OHM meter as long as you read the manual to show you which terminals to check. The door switches are also a simple switch, one for L1 the other for Neutral. 

Do you own a meter? Please answer the question...thanks.
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline oneslowqb

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 6
Re: Maytag Dishwasher
« Reply #7 on: April 29, 2009, 09:53:00 AM »
Yes, I own a meter.

 

Maytag MDBTT60AWW dishwasher.

Started by Bob

Replies: 3
Views: 7658
Last post September 07, 2007, 07:47:07 AM
by AJ
Maytag dishwasher Control panel replacement

Started by Pastyann

Replies: 1
Views: 7046
Last post September 20, 2007, 12:28:07 PM
by AJ
Maytag dishwasher shaft

Started by tucsondave

Replies: 4
Views: 3731
Last post January 04, 2008, 11:46:29 PM
by AJ
Maytag dishwasher

Started by kdeanes

Replies: 2
Views: 3511
Last post January 24, 2008, 02:02:25 PM
by RegUS_PatOff
Intermittent Problem with Maytag Dishwasher

Started by Firenut

Replies: 2
Views: 5865
Last post March 29, 2008, 12:43:53 PM
by JWWebster
Maytag Performa Dishwasher Manual

Started by Repair-man

Replies: 0
Views: 17418
Last post March 28, 2008, 08:58:14 PM
by Repair-man