Author Topic: GE Eterna Fridge  (Read 6069 times)

Offline Arizona

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 11
GE Eterna Fridge
« on: April 09, 2009, 10:47:29 PM »
I am looking for help on a GE Eterna fridge (ESS25LSPABS), 5 years old. Compressor not running

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8781
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: GE Eterna Fridge
« Reply #1 on: April 09, 2009, 11:23:10 PM »
Does your compressor have 2 pins or 3?
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline Arizona

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 11
Re: GE Eterna Fridge
« Reply #2 on: April 10, 2009, 06:10:38 PM »
The compressor has 3 pins. THe beginning of the trouble was with the start reley. The white wire looked like it had smoke on it. I went to an appliance repair store and the person suggested a 3 in 1 starter. I replaced the start relay with the 3 in 1 and it worked for a couple of weeks (2 -3) before the coils in the freezer compartment froze up. I replaced the defrost heater hoping to fix the frosting of the coils. That just didn't work out. I just replaced the defrost thermostat above the coils in the freezer compartment. The defrost heater came on after a few hours and I was starting to get happy. When I went to the fridge in the morning it was like a bad nightmare. The unit was not working at all. The night before all was good. I replaced the mainboard thinking it was the last thing I haven't done. $120 later it still isn't working. I replace the 2 pin start relay again last night, but not the single pin piece above it because the appliacne store didn't have one in stock, hoping the 3 in 1 failed. The compressor doesn't make any noise when I plug the unit into the outlet. The fan on the condensr comes on as does the fan inside the unit. If you have any suggestions other than going to appliance repair school please let me know. Is there a way to jump the starter on the compressor to check if that is the problem?

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8781
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: GE Eterna Fridge
« Reply #3 on: April 10, 2009, 07:34:54 PM »
Get an old lamp cord and connect the hard start device to it. Connect it to the compressor and see if it alone makes that compressor run.
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline Arizona

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 11
Re: GE Eterna Fridge
« Reply #4 on: April 11, 2009, 12:40:18 AM »
Is the hard start the two pin connector? Does it matter which line I connect to which pin?

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: GE Eterna Fridge
« Reply #5 on: April 11, 2009, 07:53:16 AM »
You must have the other part of the relay that was out of stock.
That was the common terminal overload and must be there for the compressor to run.
The 3n1 has 5 wires.You stated you had one hooked up already.
The 3n1 black wire goes to the single pin at the top. The white wire to the lower left, red to lower right.
The 2 remaining black wires go to hot and neutral incoming power.
« Last Edit: April 11, 2009, 07:56:25 AM by jumptrout51 »
Take a Kid fishing.

Offline Arizona

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 11
Re: GE Eterna Fridge
« Reply #6 on: April 13, 2009, 10:23:25 AM »
I had the 3n1 hooked up and the unit was working. The unit stopped working after I replaced the defrost thermostat in the freezer compartment. The fans will cycle on but the compressor will not kick on. I checked the power supply at the  compressor when the 3n1 was connected. There was power at the compressor but the compressor will not start. Is there any chance the defrost thermostat is keeping the compressor from starting?

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: GE Eterna Fridge
« Reply #7 on: April 13, 2009, 04:17:16 PM »
If you are using a 3n1 relay and you have power to the relay and the compressor is not running you have a bad compressor.
Take a VOM set to OHMs and read the 3 compressor pins to ground( a refrigerat line will do).If you get a reading the compressor is bad. If not,
Read each pin to the other pin, C to S, C to R, S to R.
C to S and C to R should total the S to R reading.
If that happens you have other issues.
Do these steps and report back.
If I am not online someone else will give you the next step.
Take a Kid fishing.

Offline Arizona

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 11
Re: GE Eterna Fridge
« Reply #8 on: April 13, 2009, 05:32:09 PM »
On the three pin compressor the pins are arranged in a triangle.
   .

.      .

Which is C, R, and S? I am guessing you are looking for the reading with the wires not connected to the compressor or will it matter if the unit is not connected to a power supply when checking?

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8781
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: GE Eterna Fridge
« Reply #9 on: April 13, 2009, 08:35:57 PM »
That hard start has 5 wires.
3 of them have compressor terminals on them
 two of them are bare wires and need to be connected to the power. The black wire goes to the top pin and is common. the white(start) wire goes to the left, the red wire(run) does to the right.
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

 

GE Eterna Fridge

Started by gotafixit

Replies: 10
Views: 11554
Last post July 03, 2009, 05:53:03 PM
by Repair-man
Repair Guide: Whirlpool Refrigerator - Water in bottom of fridge under drawers.

Started by AJ

Replies: 3
Views: 87992
Last post July 08, 2007, 12:04:06 PM
by curtis
RFA17WCE Wood's frost free all fridge not cooling

Started by Ryan

Replies: 2
Views: 5267
Last post May 14, 2008, 10:10:10 PM
by JWWebster
Whirlpool fridge water dispenser

Started by dragonlady74

Replies: 1
Views: 3133
Last post July 10, 2008, 10:30:31 AM
by Repair-man
CROSLEY FRIDGE FREEZER NOT COOLING

Started by flair

Replies: 9
Views: 8336
Last post October 15, 2009, 08:02:50 PM
by JWWebster
icemaker on Roper fridge not working

Started by ikjaj

Replies: 2
Views: 10044
Last post September 07, 2008, 10:40:55 AM
by whirlpooltech