Author Topic: Kenmore elite fridge problem  (Read 7833 times)

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Kenmore elite fridge problem
« Reply #15 on: May 09, 2009, 05:53:17 AM »
The thermistor is located in the freezer compartment on the back wall area above the evaporator. It is in a small air duct that leads to the FF damper assy. To test the thermistor, place it in a glass of ice with a small amount of water in it. The resistance should be around 16.3 OHMs.

The thermister is part number 2188819 and is shown below.

"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Kenmore elite fridge problem
« Reply #16 on: May 09, 2009, 11:04:37 AM »
Excellent
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline tomok1

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 10
Re: Kenmore elite fridge problem
« Reply #17 on: May 09, 2009, 11:13:13 AM »
Thanks Gents, I will keep you informed of the results

Offline tomok1

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 10
Re: Kenmore elite fridge problem
« Reply #18 on: May 25, 2009, 02:19:31 PM »
The final saga on the fridge that shuts off.
I ordered both thermisters for the freezer and refrigerator.
It was a very easy job to replace both.
In the freezer you must remove the back plastic that runs between the shelves.
Of course remove the two top shelves.
The plastic scoop has 2 screws and is removed easily. The thermister was just hanging there behind the air scoop.
The wire lead goes thru the to the fridge side so you have to remove the wire harness cover there which has one screw.
The baffel that controls the air from the freezer to the fridge is easily removed by compressing the clips and then the whole baffel comes out exposing the connections for both thermisters. They un plug and you just replace everything back the same way you took it apart. The whole job took no more than 20 minutes.
I checked the resistance of both new thermisters and both old ones at room temperature and in a glass with ice and water.
Only the old freezer one was almost 2 ohms lower than the orhers which of course would relate to the compresspr running to get the ohms to 8.5 where it should be. I guess sometime it ran so long the compressor just shut off.
Anyway now the temperature is exactly what it should be and it can be adjusted within 1 dec of the setting.
Sooooo I guess it is fair to say that BEFOR you replace the control board you replace the thermisters....they were $5.00 each compared to several hundred for the board.
By the way the test for thermisters using the control board only tell you when it completely malfunctions not just if it is off calibration.
Thanks for the help

Offline tomok1

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 10
Re: Kenmore elite fridge problem
« Reply #19 on: May 25, 2009, 02:25:35 PM »
As an addition....when I replaced the freezer thermister I taped it against the freezer wall.
There was no tape or mount so I just used a foil/mylar tape.
The fridge one is taped to the baffel so I used some butyl tape to make sure it was in the best place to sense the actual fridge temp.

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Kenmore elite fridge problem
« Reply #20 on: May 27, 2009, 12:19:43 AM »
you da man !!!
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

 

Kenmore elite icemaker problem

Started by underdawg247

Replies: 2
Views: 1927
Last post April 28, 2009, 01:33:14 PM
by Mr. Fix-It
Kenmore Elite - fridge compartment freezing

Started by PeterMeter

Replies: 6
Views: 5973
Last post June 12, 2009, 04:53:11 AM
by Repair-man
Kenmore Elite/Whirlpool Refrigerator - Fridge too cold

Started by taliskan

Replies: 6
Views: 3828
Last post March 26, 2011, 07:28:32 PM
by niobrara
Problem with Kenmore refrigerator not cooling, but freezer and icemaker are ok

Started by Bigmetalman

Replies: 3
Views: 5817
Last post February 13, 2008, 11:03:25 AM
by Bigmetalman
Kenmore/Whirpool fridge cooling problems

Started by woozy_one

Replies: 20
Views: 10766
Last post June 02, 2011, 08:35:17 PM
by woozy_one
Kenmore Elite SS question

Started by jrudyjr

Replies: 17
Views: 5076
Last post October 19, 2008, 09:10:30 AM
by Repair-man