Hi I am formerly Thomas68 I had troubles logging in.
My LG DLG3788W
Gas Dryer is tumbling...ignitor glowing...but no flame is being produced....
i have the front cover off and top off... i have the contol board hooked up... I have bypassed the door switch to get the dryer to work...It is in the condition above for live testing...
Do I need the door on to cause air flow over the ignitor Assembly to have the gas air mixture to flow?
does the Hi limit themistat limit the voltage going to the coils on the ignitor?
When I am doing a test in its present state Should I probe the coil connector attached to the coil or not attached to the coil?
3 Should I measure accross the 2 wire connector going wire to wire...or should I probe wire to chasis ground?? when testing for voltage at the coil..
Any help is wonderful