Author Topic: Long dry time and low temperature  (Read 11665 times)

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8781
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Long dry time and low temperature
« Reply #20 on: March 01, 2010, 03:41:33 PM »
You gotta break it down to clean it out. This is a newer model and I have not worked on one but most of these newer ones have to remove some screws on the back side and slide the top off and then the front can come off from there the dryer is exactly like that of a DOT dryer with the removable filter bladder and heater element to the right hand side on the bottom and the blower wheel to the left on the bottom.
« Last Edit: March 01, 2010, 03:47:23 PM by JWWebster »
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline dirtrider180

  • VIP Member
  • Member Since: Mar 2009
  • Posts: 30
Re: Long dry time and low temperature
« Reply #21 on: March 02, 2010, 08:37:33 PM »
I have it apart right now.  The blower wheel looks ok.  When you spin it the drum turns.  The airflow coming out the exhaust  when it was together seemed pretty good.

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8781
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Long dry time and low temperature
« Reply #22 on: March 02, 2010, 08:58:10 PM »
That filter and blower area ok?
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline dirtrider180

  • VIP Member
  • Member Since: Mar 2009
  • Posts: 30
Re: Long dry time and low temperature
« Reply #23 on: March 02, 2010, 09:22:09 PM »
Everything looks fine there.  Nothing broken, cracked.

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8781
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Long dry time and low temperature
« Reply #24 on: March 02, 2010, 10:22:31 PM »
Maybe you need to change the coils or check the connections or both.
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline dirtrider180

  • VIP Member
  • Member Since: Mar 2009
  • Posts: 30
Re: Long dry time and low temperature
« Reply #25 on: March 02, 2010, 10:33:33 PM »
I changed the coils 6 months ago.  Worked fine for 6 months.  I just changed the coils tonight and still the same problem.

Offline john63

  • Technician
  • Member Since: Feb 2010
  • Posts: 508
Re: Long dry time and low temperature
« Reply #26 on: March 02, 2010, 10:59:15 PM »
A Samsung built dryer.

If the dryer vent from the rear of the dryer to the outside vent hood of the home is absolutely/positively clear & not obstructed--replace this thermostat on the burner housing...


ITEM #20


http://www.searspartsdirect.com/partsdirect/getSubComp.pd?modelNumber=MDG9700AWW&productCategoryId=0151200&brandId=3048&brandDescription=MAYTAG&modelName=MAYTAG-LAUNDRY&diagramPageId=00003&componentDescription=BLOWER-HEATER-MOTOR&documentId=M0702017&blt=06
« Last Edit: March 02, 2010, 11:01:10 PM by john63 »

Offline dirtrider180

  • VIP Member
  • Member Since: Mar 2009
  • Posts: 30
Re: Long dry time and low temperature
« Reply #27 on: March 02, 2010, 11:05:05 PM »
I even tried running the dryer with the exhaust vent disconnected and just blowing into the room and still taking hours to dry.  The air flow coming out seems pretty strong.

Offline john63

  • Technician
  • Member Since: Feb 2010
  • Posts: 508
Re: Long dry time and low temperature
« Reply #28 on: March 02, 2010, 11:07:00 PM »
Other possible causes of erratic gas flame function:

1) Main Board (faulty relay)

2) Failing Centrifugal switch on the motor/burnt contacts (New Motor needed)

3) Failed Flame Sensor (intermittent function/burnt contacts)

4) Failing Thermistor (Ohms too low at room temperature)
« Last Edit: March 02, 2010, 11:46:00 PM by john63 »

Offline john63

  • Technician
  • Member Since: Feb 2010
  • Posts: 508
Re: Long dry time and low temperature
« Reply #29 on: March 02, 2010, 11:33:54 PM »
I even tried running the dryer with the exhaust vent disconnected and just blowing into the room and still taking hours to dry.  The air flow coming out seems pretty strong.

This can be a *very* difficult fault to diagnose.
On some Samsung dryers that I've serviced---if the symptom was:

"Poor Heating/Long Time To Dry"

or

"Igniter Glows-but-No Flame"

(The exhaust vent system is checked & okay and the gas valve coils were verified to be good)

Test Thermistor ohms at room temperature (listed as 77F) Located on blower housing.

I check the voltage from the Main Board-to-the-Gas-Valve-Coils (115 volts)

Test the Flame Sensor Switch (ohm & voltage)

Test the motor Centrifugal Switch (ohm & voltage)

In most cases--the relay on the Main Board was either erratic or failed to send voltage to the gas valve coils.

This dryer is a bit technical for the average DIYer. It may be wise to contact an authorized Samsung Service Center in your area for an out-of-warranty repair. A zip code service locator is available on Samsung's website (click "Support" first):

www.samsungusa.com
« Last Edit: March 02, 2010, 11:40:01 PM by john63 »

 

kenmore dryer 110.7XXXXXX dryer for long time

Started by hgbee

Replies: 7
Views: 4542
Last post January 29, 2008, 09:44:57 PM
by rickgburton
LG Dryer long dry time

Started by rego

Replies: 28
Views: 6082
Last post August 03, 2012, 10:37:05 AM
by AJ
Maytag Dryer LDE9701ADW noisy and taking long time to dry

Started by AJ

Replies: 0
Views: 1045
Last post January 25, 2012, 11:40:58 AM
by AJ
Kenmore(Whirlpool) Dryer Long Dry Time

Started by rego

Replies: 6
Views: 1588
Last post March 22, 2012, 09:22:11 AM
by JWWebster
Long drying times - dryer

Started by AJ

Replies: 0
Views: 1639
Last post January 21, 2008, 05:48:42 PM
by AJ
Whirlpool Dryer Can't Change Temperature

Started by TechnicianBrian

Replies: 2
Views: 2284
Last post April 10, 2008, 12:17:39 PM
by TechnicianBrian