Author Topic: spin cycle stop working  (Read 1078 times)

Offline ed

  • VIP Member
  • Member Since: Feb 2009
  • Posts: 1
spin cycle stop working
« on: March 06, 2009, 12:02:53 AM »
GE washer -the spin cycle stop working a few months ago. I was ready to scrap it before i did I noticed it was out of level so I push on the machine and it started to spin, also I cleaned the magnet on the lid. then I ran it threw two cycles and it ran fine.would the washer stop working because of a dirty lid magnet or because it is out of level?  also is there a filter in the water system ?

Model WBSE2090A

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: spin cycle stop working
« Reply #1 on: March 06, 2009, 04:40:14 AM »
Poor contact within the lid switch has stopped many a machine. Replace the lid switch. There's a new kit:




Regarding your pump question, there is no particular filtration device except for the tiny holes in the wash basket. The electric pump is subject to lint clogs and other issues, so if the tub does not drain within 70 seconds or less, replace the pump. Remember that the lid switch must be working properly for the pump to engage, so the test I recommend is only if you can hear the pump running.
« Last Edit: March 06, 2009, 06:53:31 AM by Repair-man »
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

 

front loader washer not working on spin cycle

Started by carpetguytn

Replies: 2
Views: 361
Last post January 08, 2014, 06:43:50 AM
by carpetguytn
Maytag washer mah4000aww spin cycle

Started by evo100

Replies: 1
Views: 2162
Last post December 25, 2007, 09:41:02 PM
by AJ
Kenmore frontloader 417.42142100 shaking when in spin cycle

Started by candoan

Replies: 3
Views: 3940
Last post January 28, 2008, 06:04:40 AM
by candoan
washer works except spin cycle and has a burning rubber smell.

Started by hogslayer

Replies: 4
Views: 3907
Last post February 19, 2008, 03:50:55 PM
by JWWebster
Maytag Spin Cycle

Started by Camarocam

Replies: 1
Views: 3767
Last post February 19, 2008, 11:07:58 AM
by AJ
Atlantis squeak on end of spin cycle

Started by sdjjwilliams

Replies: 5
Views: 2571
Last post February 21, 2008, 11:14:11 AM
by sdjjwilliams