Author Topic: 70 series Kenmore electric dryer spins but does not heat  (Read 37186 times)

Offline llew_x

  • VIP Member
  • Member Since: Feb 2009
  • Posts: 10
70 series Kenmore electric dryer spins but does not heat
« on: February 16, 2009, 05:26:05 PM »
Hi,

I have a 70 series electric Kenmore dryer that I've been using for about 4 years. It's worked great up until tonight when I went to take my clothes out and they were still very damp. I reset the timer and checked it again about 40 minutes later and the clothes felt the same.

I bought this dryer from a Sears outlet store that sells appliances at slightly (supposedly) reduced price because of cosmetic flaws and I don't have a user manual or any exploded views of the inside of the dryer. I have a gut feeling from reading some other posts that It's probably my coils? I'm not sure but I do need some help and was hoping someone here could please give me some assistance.

Thanks,

Model 110.66752500
llew

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #1 on: February 16, 2009, 06:32:22 PM »
check the vent. If it looks stopped up then the high limit is blown. Mounted on top of the heating element.
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #2 on: February 16, 2009, 06:48:42 PM »
Are the clothes hot and damp or cold and damp?
Take a Kid fishing.

Offline llew_x

  • VIP Member
  • Member Since: Feb 2009
  • Posts: 10
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #3 on: February 16, 2009, 07:29:37 PM »
The clothes are cold and damp.

I did take the vent hose off and ran the dryer...all that came out of the vent was cold air.

-Llew

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #4 on: February 17, 2009, 06:25:03 AM »
With your volt ohm meter (VOM) check for 220 volts at the terminal block the cord attaches to.
If 220 is present, unplug the dryer and remove the rear panel.
With meter set to continuity check the thermostats and fuses on the heater as well as the heater coil. Remember to unplug the wires to each component to check them correctly.
Take a Kid fishing.

Offline llew_x

  • VIP Member
  • Member Since: Feb 2009
  • Posts: 10
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #5 on: February 17, 2009, 02:10:08 PM »
I finally got home from work and had time to fiddle with this thing a little bit.

It seems like I have continuity on everything I put my leads to.

Just to clarify what I'm looking at... The thermostat is located in the vent just upstream from where the vent hose connects?

The fuse is located near the bottom of the heating element?

I took some pictures but I can't post them because they're too big.

-Llew

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #6 on: February 17, 2009, 04:01:13 PM »
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #7 on: February 17, 2009, 04:30:53 PM »
Where Repairman said "cord goes here". Did you read 220 volts?
Take a Kid fishing.

Offline llew_x

  • VIP Member
  • Member Since: Feb 2009
  • Posts: 10
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #8 on: February 17, 2009, 05:52:18 PM »
Repair-man, thank you for the pic that points everything out!

There are 4 wires from my plug, a black on the left, white in the middle and red on the right and of coarse the ground in upper left. While plugged in my volt meter reads 247V with the leads on red and black, O.L. if on black and white or red and white.

-Llew

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #9 on: February 17, 2009, 06:26:55 PM »
You either have your meter set wrong or you have a neutral wire problem.
You should read 120 volts from black to white and red to white for a complete circuit.

Look closely at the wires at the terminal for a burned wire.
No burned wire, open the wall outlet and inspect the wires and the female connections.

Read voltage at the wall connection for 220 volts and 120 volts from hot to neutral on both legs.
« Last Edit: February 17, 2009, 06:35:36 PM by jumptrout51 »
Take a Kid fishing.

Offline llew_x

  • VIP Member
  • Member Since: Feb 2009
  • Posts: 10
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #10 on: February 18, 2009, 05:33:37 AM »
OK, I just went and checked it again. I must have got mixed up plugging and unplugging the cord. My multimeter is definately set to measure V/AC.

From black to white or redt to white it's 120V.

Black to red is 245V. The receptacle does say 30A -125V/245V.

So i'm going to go back at it when I get out of work today to recheck the thermostats and fuses and heater coils.
In an earlier post you mentioned to make sure I unplug the wires going to each component before I check them. Should I unplug both wires or just one? And as long as I get any reading other than O.L. then that means there should be continuity and the component is working, correct?

I really do appreciate your help!

-Llew


Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #11 on: February 18, 2009, 08:52:30 AM »
With the power disconnected you should take at least one wire off each thermostat and limit just to be sure you don't somehow get a false read. 
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #12 on: February 18, 2009, 08:57:07 AM »
If it runs at all and the heating element is OK then you most likely need a limit kit. It mounts on the element canister.

Dryer Thermal Cut - Off Kit, part number: AP3094244


« Last Edit: February 18, 2009, 09:02:12 AM by JWWebster »
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline llew_x

  • VIP Member
  • Member Since: Feb 2009
  • Posts: 10
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #13 on: February 18, 2009, 08:59:50 AM »
I'm sorry, I'm not too sure what you mean by "limit" after diconnecting at least one wire from each thermostat. Could you please further explain?

I really don't mean to sound stupid but I don't want to pretend I understand advice being given when I don't fully understand... I just want to get her fixed and be up and running again.

-Llew

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: 70 series Kenmore electric dryer spins but does not heat
« Reply #14 on: February 18, 2009, 09:08:51 AM »
You dryer has a series of safetys. If the control thermostat fails, the filter housing gets blocked with lint, or the vent gets stopped up  the heat could cause a fire. The bottom cannister thermostat limit is the lowest temp one 250F, it should shut down first if it fails then the limit mounted at the top of the cannister is set to Blow at 300F When it blows that is an indication of an external vent blockage. If the problem is from within the dryer then the fuse mounted on the blower housing will blow an the dryer won't run. The fuse is rated at 350F and is tied into the door switch. That is why the wires are smaller. They don't carry the heat load. If the duct fuse blows it is the same as if you opened the door. The dryer simply quits running.
« Last Edit: February 18, 2009, 09:11:31 AM by JWWebster »
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

 

Kenmore 70 series electric dryer...wont heat

Started by lalakelley

Replies: 53
Views: 34420
Last post November 24, 2011, 02:40:03 AM
by RegUS_PatOff
Kenmore 70 series electric dryer no heat again

Started by weadhopper

Replies: 5
Views: 3896
Last post May 14, 2009, 11:13:08 PM
by JWWebster
Kenmore 70 series electric dryer no heat again

Started by connie

Replies: 10
Views: 3030
Last post June 09, 2009, 05:59:07 AM
by connie
Kenmore 70 Series Electric dryer wont heat up

Started by Paco taco

Replies: 4
Views: 6131
Last post December 29, 2009, 11:32:31 AM
by whirlpooltech
Kenmore 70 Series Electric dryer wont heat up

Started by kid_sketch

Replies: 22
Views: 6350
Last post January 21, 2010, 09:36:42 PM
by AJ
Kenmore 80 Series Electric Dryer won't heat

Started by snottrocket

Replies: 8
Views: 12469
Last post June 06, 2011, 09:35:10 PM
by JWWebster