Author Topic: Maytag Washer leaking/ throwing grease- belt chewed up-  (Read 1821 times)

Offline HIGHBERG

  • VIP Member
  • Member Since: Feb 2009
  • Posts: 1
Maytag Washer leaking/ throwing grease- belt chewed up-
« on: February 08, 2009, 08:37:57 PM »
Washer was purchased in '98 - did not realize something was wrong until we noticed the smell of rubber burning. Turned over to find quite a bit of grease thrown across the bottom and belt somewhat chewed up on one side. Pulled off pulley to check bearing, which appears to be fine- no faulty ball bearings. Any ideas??  :thinking:

Model LAT8816AAE

Offline theoldstoveguy

  • Technician
  • Member Since: Jan 2008
  • Posts: 1143
  • Country: us
    • Buy me a beer through paypal
Re: Maytag Washer leaking/ throwing grease- belt chewed up-
« Reply #1 on: February 08, 2009, 08:55:12 PM »
Lip seal,May need a tool to remove.


The genuine part # 207843


The removal tool is very expensive but the seal comes with the installation tool. I have had people say that with a good hook tool they could remove it without using the factory tool. I can't see it being done without the factory tool.( clearance issues) It is a very good machine & will just need that seal a good cleaning & some belts.

 

How to replace a Maytag - Amana washer water pump and belt.

Started by AJ

Replies: 18
Views: 25075
Last post April 19, 2010, 08:23:29 PM
by JWWebster
Maytag washer and dryer belt please

Started by msoffice2020

Replies: 4
Views: 2090
Last post December 24, 2007, 12:46:14 PM
by msoffice2020
Maytag SAV515D Washer how to replace belt

Started by jhernandez1514

Replies: 6
Views: 3096
Last post March 17, 2008, 06:15:02 AM
by Repair-man
Maytag Washer Leaking

Started by TechnicianBrian

Replies: 0
Views: 1457
Last post June 06, 2008, 01:58:24 PM
by TechnicianBrian
Maytag Washer is leaking

Started by Floridaguy

Replies: 15
Views: 6038
Last post January 26, 2009, 04:32:17 AM
by Repair-man
LAT9206B0E Maytag Washer Tub is leaking

Started by Floridaguy

Replies: 2
Views: 1394
Last post October 13, 2008, 07:45:00 PM
by Al Capone