Maytag Dishwasher Lights won't come on, seems no power

[trohm@csusb.edu]

Disher washer will not turn on.  It seems that there is no power to it.  Check circuit breakers and power to dish washer, all is fine.  Is there a fuse or other means to turn off power inside or is it the control panel?

I am at a loss.

Model MDB7600AWW

[AJ]

Hi,

Here is the service manual for your dishwasher.

16021814 Maytag Jetclean II Dishwasher Service Manual

From the service manual...

Will Not Start Or Program

Control Board

Check incoming voltage to Control Board Part # 99003160

Membrane Switch

Check for proper operation of Membrane Switch, Part # 6-917716


See membrane readings on the Technical Sheet located
behind toe panel.

NOTE: Make sure the pin connectors are making proper
contact with pins on the Control Board. If the
voltage is correct into the Control Board, and the
board will not activate, replace board.


Will Not Fill

Water Valve Part # 99002628
Check Water Valve circuit. See Technical Sheet for water
valve data located behind toe panel.

NOTE: Make sure the pin connectors are making proper
contact with pins on the Control Board.

[oneslowqb]

I had the same problem. My lights came on 5 days later but it would not work. Lights went off again. I replaced the main board but still no lights or power. Checked power hookup and all looks good. Thinking of changing out Front touch pad but is getting expensive. Have you had any luck?

[Al Capone]

Hi oneslowqb,

Do you have the same (MDB7600AWW) model number dishwasher too?

[oneslowqb]

MDBH965AWB

[Al Capone]

oneslowqb,

Being you have a different model number it would be best if you started a new topic about the problems you are having with your model number dishwasher.