Author Topic: water wont fill  (Read 1286 times)

Offline markmezzano

  • VIP Member
  • Member Since: Jan 2009
  • Posts: 1
water wont fill
« on: January 12, 2009, 12:04:26 AM »
Washer stopped last week.  Water starts to enter on wash cycle and then quickly stops.  No rinse water, washer times out.  I changed water valve and checked continuity across pressure switch and have same.  Any suggestions.

Model mah4000aww

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: water wont fill
« Reply #1 on: January 12, 2009, 05:25:06 AM »
Bad motor control board. Look down there and see.

(The machine control will shut down the machine if no tumbling is observed during the initial fill. A bad motor control will cause this and is easy to diagnose)

You will find dark scorch marks on the motor board and probably a blown inline fuse on the  board itself, niether of which is correctable without a new motor conversion kit.

Part # 12002039 Motor - Drve, AP4010145



« Last Edit: January 12, 2009, 05:29:46 AM by Repair-man »
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

 

maytag neptune front loader wont drain and now wont fill with water and spin

Started by tmcleary

Replies: 1
Views: 1132
Last post September 04, 2012, 05:42:32 PM
by Bailey
GE Washer wont fill with water

Started by smith10210

Replies: 6
Views: 3390
Last post October 01, 2012, 08:26:15 PM
by smith10210
whirlpool ultimate care II leaking water from bottom front and wont spin

Started by vasdoc

Replies: 6
Views: 6621
Last post October 12, 2008, 09:20:49 PM
by JWWebster
Kenmore Front Loader Wont Fill

Started by dksgirl

Replies: 3
Views: 1432
Last post February 01, 2009, 12:44:14 AM
by RegUS_PatOff
205613 Maytag Top Load Water Inlet Fill Valve

Started by AJ

Replies: 0
Views: 3079
Last post April 30, 2009, 11:55:15 PM
by AJ
kenmore washer 90 series won't fill water

Started by ryanbach

Replies: 9
Views: 6382
Last post August 20, 2009, 07:59:30 PM
by Washaman