Author Topic: whitest whites setting takes 2.5 to 3 hrs to finish  (Read 1631 times)

Offline cilon

  • VIP Member
  • Member Since: Jan 2009
  • Posts: 3
whitest whites setting takes 2.5 to 3 hrs to finish
« on: January 15, 2009, 06:17:37 PM »
the whitest whites setting should take 110 minutes but it has been taking about 3 hours to finish. It will run normal till it hits 1 min, then it will stay there for a long long time.

Also does anybody else's washer stink when on the whitest whites setting??? this one does.

any clues??? this thing has washed and still does wash alot of loads, all I have done to it is put in a new pump.  the diagnostics don't come up with any codes.

Model 110.42832200

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: whitest whites setting takes 2.5 to 3 hrs to finish
« Reply #1 on: January 15, 2009, 06:51:52 PM »
Does your machine function normally on "ALL" other settings?
Take a Kid fishing.

Offline cilon

  • VIP Member
  • Member Since: Jan 2009
  • Posts: 3
Re: whitest whites setting takes 2.5 to 3 hrs to finish
« Reply #2 on: January 15, 2009, 07:59:07 PM »
yeah works as it should on all other settings

Offline theoldstoveguy

  • Technician
  • Member Since: Jan 2008
  • Posts: 1318
  • Country: us
    • Buy me a beer through paypal
Re: whitest whites setting takes 2.5 to 3 hrs to finish
« Reply #3 on: January 15, 2009, 08:03:48 PM »
Hot & cold water working right? Could be a water heating delay? If your water temp is low or hoses reversed it will wait for the temperature to get up before advancing.

Offline cilon

  • VIP Member
  • Member Since: Jan 2009
  • Posts: 3
Re: whitest whites setting takes 2.5 to 3 hrs to finish
« Reply #4 on: January 15, 2009, 08:21:50 PM »
if it was a water temp deal then why does it go idle at the end of the cycle, it literally takes an hour and a half for the last 1 min to come off the screen and the door unlocks and its finally done.

Offline RegUS_PatOff

  • Technician
  • Member Since: Dec 2007
  • Posts: 1410
  • Country: us
Re: whitest whites setting takes 2.5 to 3 hrs to finish
« Reply #5 on: January 16, 2009, 04:32:00 AM »
Unlocking
Unlocking will occur only under the following conditions:
1. The drive motor speed equals 0 or the time since the drive motor STOP command has
been sent to the Motor Control Unit is greater than 180 seconds.
2. The time since the inlet valve was CLOSED is greater than five (5) seconds.
3. If the temperature of the water is greater than 122F (50 C), the water will be drained before unlocking will occur.
4. If the water level is higher than the wash level in the Delicate, Wool or Handwash cycles, the water will be drained before unlocking will occur.

maybe the Temperature Sensor is bad ?
maybe the Water Level Sensor is bad ?
After leaving this Earth, "Do you want the smoking or non-smoking section?"

 

Maytag wont agitate in any setting

Started by celinda

Replies: 3
Views: 1429
Last post January 24, 2010, 05:59:41 PM
by Repair-man
Kenmore/Frigidaire 417.43042200 Doesn't finish cycle

Started by highestfi

Replies: 4
Views: 1171
Last post October 25, 2011, 08:15:03 PM
by highestfi
Kenmore 110 28002011 will not finish cycle

Started by itisfixed

Replies: 4
Views: 793
Last post October 13, 2013, 10:48:57 AM
by itisfixed
Frigidaire CRTF1240A - washer takes a LONG time, maybe forever

Started by jiggersplat

Replies: 1
Views: 468
Last post October 21, 2013, 09:05:31 AM
by Cananot