Author Topic: LSQ9549LG0 taking a walk  (Read 1297 times)

Offline peachy1

  • VIP Member
  • Member Since: Nov 2007
  • Posts: 1
LSQ9549LG0 taking a walk
« on: November 15, 2007, 11:31:53 AM »
First the washer is level. It only happens on high spin. If you are looking at the washer from the front the left side comes out about 4 inches.How do I remove the cabinet. On the console I have 2 hex screws 2 push tabs(on the back) and 2 philip heads screws seem to a  attach to the cabinet. What parts do you think I need!!!

Model Number: LSQ9549LG0 icon

Offline rickgburton

  • Technician
  • Member Since: Oct 2007
  • Posts: 228
  • Country: us
  • Ricks Appliance Repair - 30 Years Experience
    • Buy me a beer through paypal
Re: lsq 9549l taking a walk
« Reply #1 on: November 15, 2007, 07:28:40 PM »
On the front of the console, remove the two phillips screws. Pull forward on the console and lean back out of the way. Disconnect the lid switch connector on the right side. Remove the two big clips on either side. Then tip the cabinet forward and it will come off. Look at the frame sides and you'll see two tabs that stick up near the legs ( two on each side ). The cabinet has four slots the tabs go into when putting it back on.
OWNER/SERV TECH: RICK'S APPLIANCE REPAIR
APPLIANCE SERVICE TECHNICIAN FOR 25 YEARS
ONLINE SERV TECH: ApplianceBlog.com ApplianceJunk.com
CERTIFIED TYPE 1; TYPE 2.....REFRIGERATION SERV

 

Spins to the point the washer wants to walk

Started by RoundRockTx

Replies: 3
Views: 1414
Last post December 15, 2008, 01:39:12 PM
by Repair-man
Maytag washer sounds like a plane taking off during spin cycle.

Started by justinc25

Replies: 6
Views: 3741
Last post April 05, 2009, 09:44:04 AM
by justinc25
Sounds Like Jet Taking Off when Kenmore Front Loader in Spin Cycle (Bearings?)

Started by freddy101

Replies: 7
Views: 3034
Last post February 19, 2010, 04:32:28 AM
by schaffersapplian
Whirlpool Cabrio washer sounds like a jet taking off in the spin cycle

Started by cindid

Replies: 4
Views: 6196
Last post August 13, 2013, 09:56:11 AM
by tgoods