Author Topic: maytag tall tub dishwasher  (Read 2352 times)

Online RAH52

  • Technician
  • Member Since: Aug 2008
  • Posts: 684
  • Country: ca
maytag tall tub dishwasher
« on: July 23, 2009, 08:07:14 PM »
This dish washer acts weird . Only a few buttons on the console will work ,other times other buttons will work . It will never cancel drain and sometimes the time will jump from the time on the display to 1 and a few leds will flash and it goes back to the previous time . My question is this ..is there a fool proof method of telling which component is bad ,the console or the control board . Does any one know how to test the console ? The tendency would to change them both but its very expensive

Model MDB6601AWW 

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: maytag tall tub dishwasher
« Reply #1 on: July 24, 2009, 03:44:01 AM »
The "fool proof" method is to have a replacement membrane that you can plug into the ribbon connector on the board.  This is what the service manual recommends when cycles don't set properly. Do you need a copy of the service manual for this one?
« Last Edit: July 24, 2009, 03:50:24 AM by Repair-man »
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline centralappliance

  • Technician
  • Member Since: Jul 2009
  • Posts: 76
  • Country: ca
Re: maytag tall tub dishwasher
« Reply #2 on: July 28, 2009, 08:54:26 PM »
I had a similar problem with the Maytag Quiet series 300. The problem was the membrain/keypad. Electronic modules normally either work or dont work. Keypads get wet and corroded and cause strange problems

Offline MajorApp

  • Technician
  • Member Since: Feb 2008
  • Posts: 547
  • Country: us
Re: maytag tall tub dishwasher
« Reply #3 on: July 28, 2009, 10:05:45 PM »
 I have the same dishwasher and the touchpad lights quit working but the front display works so I push the desired wash cycle and push start and it works fine. I know I need to either try and clean the contacts or replace the control panel. One of these days

 

16026945 Maytag Convertible Tall Tub Dishwasher Service Repair Manual

Started by whirlpooltech

Replies: 0
Views: 2525
Last post March 30, 2008, 08:49:30 AM
by whirlpooltech
16022783 Maytag Tall Tub Jet Clean II Stainless Steel Dishwasher Service Manual

Started by AJ

Replies: 0
Views: 1536
Last post August 20, 2009, 04:33:50 PM
by AJ
Maytag MDBTT60AWW dishwasher.

Started by Bob

Replies: 3
Views: 7219
Last post September 07, 2007, 07:47:07 AM
by AJ
Maytag dishwasher Control panel replacement

Started by Pastyann

Replies: 1
Views: 6623
Last post September 20, 2007, 12:28:07 PM
by AJ
Maytag dishwasher shaft

Started by tucsondave

Replies: 4
Views: 3312
Last post January 04, 2008, 11:46:29 PM
by AJ
Maytag dishwasher

Started by kdeanes

Replies: 2
Views: 3211
Last post January 24, 2008, 02:02:25 PM
by RegUS_PatOff