« previous next »
Pages: [1]   Go Down

Author Topic: no heat in regular dry cycle -some in permanent press cycle  (Read 3139 times)

Offline OntarioDavid

  • VIP Member
  • Member Since: Dec 2008
  • Posts: 8
no heat in regular dry cycle -some in permanent press cycle
« on: December 24, 2008, 09:52:04 AM »
any suggestions for a fix? I had a repair man replace the door switch just a month ago and everything worked OK until 2 days ago. Don't want to pay for another service call

Model 110.c70722991
Logged


Offline OntarioDavid

  • VIP Member
  • Member Since: Dec 2008
  • Posts: 8
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #1 on: December 24, 2008, 09:54:18 AM »
this is a KENMORE 70 series HD super capacity plus gas dryer- 7years ol
Logged

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8640
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #2 on: December 24, 2008, 10:02:07 PM »
I gotta say that is a bad timer. For many reasons.
Logged
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline RegUS_PatOff

  • Technician
  • Member Since: Dec 2007
  • Posts: 1378
  • Country: us
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #3 on: December 25, 2008, 11:02:03 AM »
are you sure there's no heat in the Regular Dry Cycle, not even in the first few minutes ?
Logged
After leaving this Earth, "Do you want the smoking or non-smoking section?"

Offline OntarioDavid

  • VIP Member
  • Member Since: Dec 2008
  • Posts: 8
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #4 on: December 31, 2008, 06:42:37 PM »
OK I've done some close monitoring. Starts with heat, BUT heat stops after just a few minutes-less than five minutes before no heat
Logged

Offline RegUS_PatOff

  • Technician
  • Member Since: Dec 2007
  • Posts: 1378
  • Country: us
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #5 on: December 31, 2008, 07:06:08 PM »
common problem, cheap,easy fix.

intermittent Gas Valve Coils

click on picture $ 20.05

Logged
After leaving this Earth, "Do you want the smoking or non-smoking section?"

Offline OntarioDavid

  • VIP Member
  • Member Since: Dec 2008
  • Posts: 8
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #6 on: January 01, 2009, 09:38:38 AM »
Thanks for the speedy response. I'm a real rookie at this. Can you tell me where to look for this item on the back of the dryer
Logged

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1841
  • Country: us
    • Buy me a beer through paypal
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #7 on: January 01, 2009, 09:56:51 AM »
After you remove the front panel you will see it mounted to the bottom plate of the dryer.
Turn off your gas and unplug your electrical cord first.
Logged
Take a Kid fishing.

Offline OntarioDavid

  • VIP Member
  • Member Since: Dec 2008
  • Posts: 8
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #8 on: January 01, 2009, 12:13:43 PM »
so, this is not accessible by removing the BACK. Top off first and then the front panel. This will be under the big drum then?
Logged

Offline OntarioDavid

  • VIP Member
  • Member Since: Dec 2008
  • Posts: 8
Re: no heat in regular dry cycle
« Reply #9 on: January 01, 2009, 12:31:39 PM »
EUREKA I think I've found it. Is there any special process for removing the drum
Logged

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1841
  • Country: us
    • Buy me a beer through paypal
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #10 on: January 01, 2009, 12:56:15 PM »
Quote from: OntarioDavid on January 01, 2009, 12:31:39 PM
EUREKA I think I've found it. Is there any special process for removing the drum

Look under the drum and remove the belt from the motor pulley. Then the drum will pull out.
It is not necessary to remove the drum to replace the GV coils.
Logged
Take a Kid fishing.

Offline OntarioDavid

  • VIP Member
  • Member Since: Dec 2008
  • Posts: 8
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #11 on: January 01, 2009, 01:41:01 PM »
OH OH, Got excited jiggled the drum and now its out. Can't figure out how the belt goes around the motor and tensioner? Can you draw me a picture?
Logged

Offline OntarioDavid

  • VIP Member
  • Member Since: Dec 2008
  • Posts: 8
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #12 on: January 01, 2009, 02:09:00 PM »
WOO HOO ...I got the belt path figured out. Now for the replacement pieces. Can I order these from this site? Do you ship to Canada? I'm guessing that replacement of both these valves at the same time is necessary
Logged

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1841
  • Country: us
    • Buy me a beer through paypal
Re: no heat in regular dry cycle -some in permanent press cycle
« Reply #13 on: January 01, 2009, 02:46:59 PM »
Yes, order from this site.
Yes, replace both at same time.
Good luck.
Logged

Take a Kid fishing.
Pages: [1]   Go Up
« previous next »
 

Kenmore Electric Dryer - Quits in mid-cycle

Started by GaryGG

 Replies: 5
Views: 2659 		Last post February 15, 2008, 04:07:19 PM
by JWWebster
Simpson Maxi Dry 505 (reverse cycle clothes dryer)

Started by laudesan

 Replies: 6
Views: 2215 		Last post April 26, 2008, 06:36:15 PM
by laudesan
maytag dryer Auto Dry Cycle

Started by wolfen327

 Replies: 2
Views: 3401 		Last post September 08, 2008, 08:39:31 PM
by Repair-man
Kenmore Dryer Stops During a Cycle

Started by TechnicianBrian

 Replies: 0
Views: 3818 		Last post November 15, 2008, 08:27:31 AM
by TechnicianBrian
Whirlpool Dryer Stops Tumbling Mid Cycle

Started by zuker88

 Replies: 11
Views: 6996 		Last post December 13, 2008, 04:45:14 PM
by JWWebster
Moisture Sensor / Automatic Dry cycle?

Started by thewavgod

 Replies: 1
Views: 1038 		Last post May 09, 2011, 12:18:33 PM
by Repair-man