« previous next »
Pages: [1]   Go Down

Author Topic: shifter  (Read 1598 times)

Offline JPG

  • VIP Member
  • Member Since: Nov 2007
  • Posts: 111
shifter
« on: December 14, 2008, 07:51:58 AM »
hi had anybody out there ever replaced the shifter/xmission on this model?? I have a very loud shifter. Is there anythilng else i need bearings, seals, etc when u replace this shifter???

tks  joe

Model wbb4500gww
Logged


Online JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8640
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: wbb4500gww
« Reply #1 on: December 14, 2008, 11:13:26 AM »
Can't get the model to show up. can you post some pictures?
Logged
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline RegUS_PatOff

  • Technician
  • Member Since: Dec 2007
  • Posts: 1378
  • Country: us
Re: shifter
« Reply #2 on: December 14, 2008, 05:40:42 PM »
Logged

After leaving this Earth, "Do you want the smoking or non-smoking section?"
Pages: [1]   Go Up
« previous next »
 

mode shifter

Started by gkofc

 Replies: 14
Views: 5384 		Last post February 16, 2010, 09:34:50 AM
by JWWebster
wcre6270h1ww shifter/control board

Started by JPG

 Replies: 4
Views: 510 		Last post October 17, 2012, 02:05:24 PM
by fairbank56
31-9145 Profile Washers With Electronic Control and Mode Shifter Assembly Service Manual

Started by AJ

 Replies: 0
Views: 176 		Last post December 30, 2012, 10:45:17 AM
by AJ
MODEL MVWX700XW SHIFTER WIRE HARNESS

Started by gregaguilar

 Replies: 1
Views: 183 		Last post January 09, 2013, 08:53:23 PM
by tgoods
GE Hydro Wave Washer -Mode Shifter Ghetto Repair

Started by goodsusedappliance

 Replies: 18
Views: 918 		Last post April 07, 2013, 10:30:53 PM
by Wedgeman55