Author Topic: Admiral Oven turning itself off after about 15-20 sec after set to bake  (Read 1322 times)

Offline Redman

  • VIP Member
  • Member Since: Dec 2008
  • Posts: 1
I have a Admiral Mircowave/ oven combo.  the model number sticker is worn off mostly.  the only part of the number I can read is I think an A and then 1 or 2 letters/numbers missing then a 59 blank N -51VWM  The sticker in the microwave also states Magic chef and year 1991
The microwave is a CM47FN-14T and it has the controlls for the oven on it.  (Wall unit) When I press bake and spin the nob to 350 or any temp it clicks on as normal but then after about 15 seconds it shuts of as if I was pressing stop/clear button
Any help would be appreciated

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Oven turning itself off after about 15-20 sec after set to bake
« Reply #1 on: December 10, 2008, 03:50:56 AM »
It is an electronic control failure. I doubt you can get parts any more, nor would the expense be worth it.
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

donate
$1, $2, $5, $10, $20, $50
 

GE Oven doesn't reach temperature (120-150 Below setting)bAKE

Started by Earl Dryer

Replies: 12
Views: 4865
Last post June 01, 2008, 02:31:32 PM
by RegUS_PatOff
Whirlpool oven "bake" setting doesn't light up.

Started by jaworf

Replies: 6
Views: 3991
Last post August 10, 2008, 08:33:54 AM
by jaworf
Frigidaire Oven upper element not fully heating up on bake cycle

Started by prconsulting

Replies: 2
Views: 3419
Last post December 28, 2008, 09:20:32 AM
by jumptrout51
74008064 Maytag Jenn Air Bake Broil Oven Range Ignitor

Started by AJ

Replies: 0
Views: 4539
Last post April 09, 2009, 08:49:06 PM
by AJ
9750213 KitchenAid Oven Bake Element

Started by AJ

Replies: 0
Views: 3489
Last post May 03, 2009, 09:59:07 AM
by AJ
W10276482 Maytag Range Oven Bake Element

Started by AJ

Replies: 0
Views: 3709
Last post July 30, 2009, 04:26:41 PM
by AJ