Author Topic: Kenmore Bad Lid Switch  (Read 2569 times)

Offline DJ

  • VIP Member
  • Member Since: Dec 2008
  • Posts: 4
Kenmore Bad Lid Switch
« on: December 03, 2008, 11:57:01 AM »
I need to replace the lid switch but can't figure out how to get the top off so i can get to it

Model 110.22702100

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8797
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Kenmore Bad Lid Switch
« Reply #1 on: December 03, 2008, 01:41:36 PM »
What you do is flip up the control panel and pop the S clips, tip the cover foward and then you can get to it.
Check out Repairman's guide to removing the case:
sublime appliance repair also has a page on this.
« Last Edit: December 03, 2008, 01:44:50 PM by JWWebster »
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL


Kenmore 90 Series won't drain/spin and is not Lid Switch

Started by jyck

Replies: 1
Views: 5585
Last post November 16, 2008, 09:46:37 PM
by JWWebster
Kenmore 90 Series won't drain/spin and is not Lid Switch

Started by gleg

Replies: 11
Views: 13363
Last post July 16, 2011, 09:23:24 PM
by JWWebster
Kenmore 800 Series - Cold & Hot Reversed: Needs which Switch?

Started by rockinrobin

Replies: 7
Views: 373
Last post September 15, 2014, 08:18:30 PM
by Maytag Man 6725
Kenmore 400 washer won't drain or spin - No blockage, Not switch, Not coupler.

Started by BoldL1k3L1on5

Replies: 0
Views: 526
Last post February 04, 2015, 03:31:10 PM
by BoldL1k3L1on5
Kenmore Elite Top of the Line quit spinning

Started by Bishop

Replies: 11
Views: 11731
Last post September 06, 2007, 05:24:55 PM
by AJ
How do I access Kenmore Washer Timer. 11023034100?

Started by wsommariva

Replies: 7
Views: 15776
Last post September 02, 2007, 04:58:36 PM
by AJ