I'm working on a GE Hydrowave Infuser washer with the precise fill option. When you push the start button and it starts to fill with water it immediately starts spinning. It is supposed to spin at 15 rpm while filling to wet the clothes but this thing is going wide ass open 700 rpm. Doesn't matter if the precise fill option or the manual water level is selected it still does it. Now, if I open the lid and let it fill up with the lid open it will fill up normally because the lid switch is open and the motor is stopped (like it should be) and after it is done filling I can close the lid and it shifts into wash mode and finishes the cycle normally. In field service mode it has no error codes on the display and all the field service tests are normal. No error codes on motor either. So am I looking at a control board replacement or am I missing something here? Don't want to just start throwing parts at the thing. Thanks for any input you guys can give me!