Author Topic: Kitchenaid Built-in Microwave no Cavity Lamp  (Read 2695 times)

Offline TechnicianBrian

  • Technician
  • Member Since: Dec 2007
  • Posts: 390
  • Country: us
    • TechnicianBrian.com
Kitchenaid Built-in Microwave no Cavity Lamp
« on: November 05, 2008, 05:28:15 AM »

Model #KEMC308KSS0icon, this built-in oven with microwave was functioning properly, but the cavity light in the microwave section would no longer operate when the door was opened. The customer found what he thought was the end of the bulb in the middle of the top, but couldn't figure a way to replace it. After enough looking around and removing screws, he gave in and called for service.



The light bulb in this microwave, like most others, will turn on when the door is opened, or the microwave is in use. Most bulb are not easily user changeable for safety reasons on built-in or counter top units, while many over the range units will have a bulb access door behind the vent grill. The bulb on this particular model is a halogen style, running on low voltage AC current provided by a step down transformer located behind the control panel.

When trouble shooting a no light situation, we must determine whether it is the bulb, the transformer, or the wiring that is the at fault. If you are playing the odds, go for the bulb, but I encourage people to do some basic checks so the correct part is ordered the first time. With the control panel tipped up out of the way, the output from the transformer can be checked for proper power. Be aware this unit has three separate transformers so you must check the correct output which is the two pink wires. A voltage of around 18vac when the microwave door was opened would be correct indicating the bulb is bad. If you don't have voltage, then either the transformer is bad, or the control board is not powering the transformer.

In the case of this unit, the bulb was bad and needed to be replaced. The process for getting to the bulb is rather involved and way past the scope of this post, but with the appropriate screws removed, I pulled the microwave out of the cabinet. The bulb is held in place with a metal clip and the end slips into a glass lens which is the part you see from the inside. Once the new light bulbicon was mounted back in place and connected to the harness, I turned the circuit breakers back on and found light again in the microwave. No more hot pockets in the dark for this customer.

 

KAC-46 KitchenAid 27 30 Electric Built-In Microwave Combo Service Repair Manual

Started by AJ

Replies: 0
Views: 2400
Last post August 18, 2009, 12:38:07 PM
by AJ
KAC-45 KitchenAid KA Built-In Microwave Oven Service Repair Manual

Started by AJ

Replies: 0
Views: 2095
Last post August 18, 2009, 12:45:49 PM
by AJ
4321783 KitchenAid Built-in Microwave Oven Service Manual

Started by AJ

Replies: 0
Views: 1777
Last post August 18, 2009, 02:18:22 PM
by AJ
KAC-25 KitchenAid Built-In Microwave/Oven Combination Service Manual

Started by AJ

Replies: 0
Views: 2056
Last post August 18, 2009, 02:25:36 PM
by AJ
KitchenAid KEHC379J Built-In Microwave Door Error

Started by billharr

Replies: 2
Views: 1473
Last post June 23, 2014, 07:29:56 PM
by billharr
Kitchenaid Microwave Not Heating

Started by TechnicianBrian

Replies: 0
Views: 4372
Last post April 10, 2008, 09:58:25 PM
by TechnicianBrian