Author Topic: LSR7233HQ Whirlpool washer  (Read 1172 times)

Offline billywood

  • VIP Member
  • Member Since: Oct 2008
  • Posts: 1
LSR7233HQ Whirlpool washer
« on: October 22, 2008, 08:04:20 AM »
The top half of the agitator has gotten loose and makes a banging sound while operating.  The lower agitator is rock solid. Machine works fine other than this.  Is there a way to tighten this part or is this normal wear and tear?  Machine is ten years old.

Many thanks to anyone who can help!

Lee

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3020
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Whirlpool washer
« Reply #1 on: October 22, 2008, 08:14:34 AM »
Try this:   (part # 285811) Good instructions in the package.

« Last Edit: October 22, 2008, 05:35:04 PM by Repair-man »
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8781
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Whirlpool washer
« Reply #2 on: October 22, 2008, 05:21:22 PM »
On kenmore/whirlpool models they use a 2 piece agitator with a set of 4
Agitator dogs inside it. As the washer rotates back and forth, the dogs grab the inner walls of the upper agitator and that forces the clothes into a downward movement to the bottom of the tub. These dogs will wear out. To test whether or not these are bad just grab the agitator while in wash mode. The dogs should advance the top portion easily. If not then they are worn out. To replace them you must remove the agitator and sit it on the floor. Hold the base down with your feet and yank the top upwards. After seperating the 2 pieces you simply install the new dogs and line up the bottom with the top being careful not to break the little tabs on the bottom agitator that hold the top in place.

May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

 

Repair Guide: Whirlpool Direct Drive Washer - No agitate or spin

Started by AJ

Replies: 13
Views: 28452
Last post January 02, 2009, 01:09:38 PM
by AJ
Video: Whirlpool Washer Motor - Bad connection..

Started by AJ

Replies: 3
Views: 3214
Last post July 29, 2013, 06:32:05 PM
by AJ
Video: Whirlpool Made Direct Drive Washer Motor Coupler Replacement

Started by AJ

Replies: 18
Views: 43009
Last post May 18, 2010, 06:53:50 AM
by gimpyjones
Video: How To Replace a Water Pump On A Whirlpool Made Direct Drive Washer

Started by AJ

Replies: 0
Views: 8727
Last post August 10, 2007, 08:42:54 PM
by AJ
whirlpool belt drive washer won't spin

Started by mthd60sprty

Replies: 7
Views: 7519
Last post June 06, 2013, 08:42:12 AM
by fairbank56
Whirlpool washer not agitating

Started by jdman

Replies: 25
Views: 29122
Last post January 18, 2013, 10:28:43 PM
by AJ