I came home to my wife explaining that she was trying to do a load of laundry and she came down to see it stopped and flashing F. She had fiddled with it quite a bit, power off/on the washer and unplugging/plugging it in. It is now in a state where the front panel has lights and displays but does not respond until I unplug it and plug it back in. At that point, I can select different cycles and all other buttons respond. Once I hold down the start button it locks the door and makes a single clicking noise which I am assuming is the beginning of the process where it calls for water, however, it does not fill. I have checked the water source and the filters are free of debris. It will sit there and do nothing. When I hit the stop button it makes another beep and acts like it has stopped the cycle with the minutes flashing. I hit it again and the minutes stop flashing. Then the entire control panel seems to lock up and I am unable to get the door open. I have to actually pull the door release by removing the front bottom panel. There are no more f-codes whatsoever. I'm thinking it could be the control panel as it seems to simply stop responding after playing with it and I also cannot seem to get the diagnostic program to launch. I put it on the "rinse and drain" cycle as the manual says and hit the "2nd rinse" button 4 times in under 5 seconds and it simply toggles back and fourth between 25 and 15 min. The diagnostics never launch. I thank anyone in advance for any help offered.